JVC KD-S25 Installation Manual - Page 1

JVC KD-S25 - MP3/WMA/CD Receiver With Remote Manual

Page 1 highlights

GET0562-002A [J] KD-S25 Installation/Connection Manual Manual de instalación/conexión ENGLISH ESPAÑOL PREPARATIONS You need the installation kits which corresponds to your car. • Mark all the check boxes ( ) to make sure you have follow the instructions and the listed parts. Check the battery system in your car 12 V DC, NEGATIVE ground Prepare this before installation 0508DTSMDTJEIN EN, SP © 2008 Victor Company of Japan, Limited TROUBLESHOOTING • The fuse blows. * Are the red and black leads connected correctly? • Power cannot be turned on. * Is the yellow lead connected? • No sound from the speakers. * Is the speaker output lead short-circuited? • Sound is distorted. * Is the speaker output lead grounded? * Are the "-" terminals of L and R speakers grounded in common? • Noise interfere with sounds. * Is the rear ground terminal connected to the car's chassis using shorter and thicker cords? • This unit becomes hot. * Is the speaker output lead grounded? * Are the "-" terminals of L and R speakers grounded in common? • This unit does not work at all. * Have you reset your unit? Parts list for installation and connection A Control panel B Sleeve C Trim plate D Power cord E Washer (ø5) F Lock nut (M5) G Mounting bolt- M4 × 5 mm (M4 × 1/4"); M5 × 12.5 mm (M5 × 1/2") INSTALLATION If you are not sure how to install this unit correctly, consult your JVC car audio dealer. In dash-mounting H Rubber cushion I Handles J Remote controller K Battery Removing the unit Before removing the unit, release the rear section. Do the required electrical connections. When you stand the unit, be careful not to damage the fuse on the rear. Bend the appropriate tabs to hold the sleeve firmly in place. Dashboard When using the optional stay Fire wall Stay (option) When installing the unit without using the sleeve In a Toyota car for example, first remove the car radio and install the unit in its place. Flat type screws -M5 × 8 mm (M5 × 3/8")* * Not supplied for this unit. Screw (option) Install the unit at an angle of less than 30˚. Bracket* Pocket Bracket* Flat type screws -M5 × 8 mm (M5 × 3/8")* 1

  • 1
  • 2
  • 3
  • 4

KD-S25
Installation/Connection Manual
Manual de instalación/conexión
GET0562-002A
[J]
PREPARATIONS
You need the installation kits which corresponds to your car.
• Mark all the check boxes (
) to make sure you have follow the instructions and the listed parts.
Check the battery system in your car
Prepare this before installation
1
0508DTSMDTJEIN
EN, SP
© 2008 Victor Company of Japan, Limited
ENGLISH
ESPAÑOL
12 V DC, NEGATIVE ground
The fuse blows.
* Are the red and black leads connected correctly?
Power cannot be turned on.
* Is the yellow lead connected?
No sound from the speakers.
* Is the speaker output lead short-circuited?
Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
This unit does not work at all.
* Have you reset your unit?
TROUBLESHOOTING
I
Handles
E
Washer (ø5)
F
Lock nut (M5)
G
Mounting bolt—
M4 × 5 mm (M4 × 1/4");
M5 × 12.5 mm (M5 × 1/2")
H
Rubber cushion
A
Control panel
B
Sleeve
C
Trim plate
D
Power cord
Parts list for installation and connection
J
Remote controller
K
Battery
When using the optional stay
Install the unit at an angle of
less than 30˚.
Screw (option)
Stay (option)
Fire wall
Dashboard
*
Not supplied for this unit.
Flat type screws
—M5
×
8 mm (M5
×
3/8")
*
Pocket
Flat type screws
—M5
×
8 mm (M5
×
3/8")
*
Bracket
*
Bracket
*
Removing the unit
In dash-mounting
Before removing the unit, release the rear section.
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
Do the required electrical
connections.
Bend the appropriate tabs
to hold the sleeve firmly
in place.
When you stand the unit, be careful
not to damage the fuse on the rear.
INSTALLATION
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.