JVC KD-X330BTS Instruction Manual - Page 26
Symptom, Remedy
View all JVC KD-X330BTS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Bluetooth® Bluetooth® TROUBLESHOOTING Symptom No Bluetooth device is detected. Pairing cannot be made. Echo or noise occurs. Phone sound quality is poor. Sound is being interrupted or skipped during playback of a Bluetooth audio player. The connected Bluetooth audio player cannot be controlled. Remedy • Search from the Bluetooth device again. • Reset the unit. ( 3) • Make sure you have entered the same PIN code to both the unit and Bluetooth device. • Delete pairing information from both the unit and the Bluetooth device, then perform pairing again. ( 9) • Adjust the microphone unit's position. ( 9) • Check the [ECHO CANCEL] setting. ( 11) • Reduce the distance between the unit and the Bluetooth device. • Move the car to a place where you can get a better signal reception. • Reduce the distance between the unit and the Bluetooth audio player. • Turn off, then turn on the unit and try to connect again. • Other Bluetooth devices might be trying to connect to the unit. • Check whether the connected Bluetooth audio player supports Audio/Video Remote Control Profile (AVRCP). (Refer to the instructions of your audio player.) • Disconnect and connect the Bluetooth player again. Symptom "PAIRING FULL" "PLEASE WAIT" "BT DEVICE NOT FOUND" "NOT SUPPORT" "ERROR" "H/W ERROR" Remedy The number of registered devices has reached its limit. Retry after deleting an unnecessary device. ( 13, DELETE PAIR) The unit is preparing to use the Bluetooth function. If the message does not disappear, turn off and turn on the unit, then connect the device again. The unit failed to search for the registered Bluetooth devices during [AUTO CNNCT]. Turn on Bluetooth from your device and connect manually. ( 13) The connected phone does not support Voice Recognition feature. Try the operation again. If "ERROR" appears again, check if the device supports the function you have tried. Reset the unit and try the operation again. If "H/W ERROR" appears again, consult your nearest service center. If you still have troubles, reset the unit. ( 3) 22