JVC LT 42P300 Instructions - Page 18

Remote Control The following pages gives you a brief description of each button's function. This remote can also control up to four other devices. See pages 51 - 52. Allows you to set the TV to turn on and set the TV to turn off automatically after a set amount of time and channel of your choice. On Timer / Input / Sleep Timer TIMER POWER Timer On Timer Input Sleep Timer 0h 0m 0 - 0 0 min Notes: • If you set the interval of On Timer by pressing the ¥ Š buttons, select channel at Input and press OK. • After you set On Timer and turn off the TV, power lamp lights. • You can check the remaining time of On Timer by displaying this menu again. • You can set the interval of Sleep Timer by pressing the ¥ Š buttons. • 60 seconds before the TV turns off, a message will appear and it will count the remaining time. • See page 50, "On Timer using iPod". Turns the TV on or off. MODE TV STB VCR DVD AUDIO V1 V2 V3 V4 V5 1 2 3 4 5 6 7 8 9 RETURN + TUNE 0 TV TUNE Switch between "TV / STB / VCR / DVD / AUDIO devices. See page 51. Switch between devices connected to Video-1, 2, 3, 4 and 5. For V4 (Video-4) and V5 (Video-5) you must select the signal input type first (ie. composite, S-Video, or component). To do so, you need to press the V4 or V5 button until the correct type is highlighted. Select "Composite 1" for composite video signal input, "S-Video" for S-video signal input, or "Component 1" for component video signal input. Select "Composite 2" for composite video signal input or "Component 2" for component video signal input. Select PC for PC signal input. Change channels. Input remote codes. See page 51. Lets you decide the input channel and select it. After pressing the remote 0 - 9 buttons, press TUNE. 18