JVC SR-9168U SR-9168U Timelapse Recorder Instruction Manual (633KB) - Page 10

2 CONTROLS AND CONNECTORS MIC IN CAM SW ALARM ALARM COM SERIES/CLOCK OUT IN REC OUT WARNING COM ALARM TAPE /REC RESET END OUT OUT IN OUT REMOTE VIDEO AUDIO IN IN OUT OUT CAM SW ALARM ALARM COM SERIES/CLOCK OUT IN REC OUT WARNING COM ALARM TAPE /REC RESET END OUT OUT IN OUT 17 16 15 14 13 12 11 10 9 9 [SERIES/CLOCK IN] series recording signal/clock reset signal input terminal Input the series recording signals, VCR activation signals from the external control equipment or clock reset signals. Select the input signal with the menu switch. • Series recording signal input When the menu switch is set to "SERIES", the series recording signal is input. • Connect to the other VCR series recording signal output terminal. • When a series recording signal is received from the other VCR, recording starts automatically. • VCR activation signal input • When the menu switch is set to "EXT", recording start and stop can be controlled with external signal input. • Connect to an external control device. When a VCR activation signal (ground input) is received, recording starts automatically and continues for as long as the VCR activation signals are input. • Clock reset signal input When the menu switch is set to "C.ADJ", the clock reset signal from the master clock can be received. • Inputting the clock reset signal synchronizes the time with the master clock time if the time difference is within ±30 seconds. If the difference exceeds 30 seconds, the time will not be adjusted correctly. 0 [WARNING/REC OUT] warning signal/rec signal output terminal Outputs a warning signal or recording mode signal. The type of output signal can be selected with the menu switch. • Warning signal output When the menu switch is set to "WARNING", a warning signal (+12 V) is output if an abnormality occurs in tape transport or mechanism operation. 10 Connecting the wires to the terminals 9 to & button 1. Hold the button down and insert the wire over the top of the terminal. 2. Release the button to lock the wire in the terminal. • Recording mode signal output When the menu switch is set to REC and the unit is in the Record mode, the recording mode signal (+12 V) is output. ! [COM] common ground terminal Connect to the ground terminal of a connected unit. @ [TAPE END OUT] tape end signal output terminal Outputs a Tape End signal when the tape ends during recording. • Outputs a +12 V signal during recording, playback, FF and rewind. When the tape ends during recording, a 0 V (GND level) signal is output. • When the tape ends during auto repeat recording, signals are output for about 2 seconds. • Connect an external alarm lamp or buzzer via an external interface. • To cancel the output, press the EJECT button, PLAY button, FF button or REW button. The timing of the tape end signal output during recording can be selected with the menu switch (at tape end, or 3 minutes or 6 minutes before the tape ends during 6H mode). # [ALARM REC OUT] alarm recording mode signal output terminal Outputs +12 V signals during alarm recording. $ [ALARM RESET] alarm signal reset input terminal Receives signals to cancel alarm recording. • Alarm input data is not reset. % [ALARM IN] alarm signal input terminal Receives signals to start alarm or sensor recording. ^ [COM] common ground terminal Connect to the ground terminal of a connected unit. & [CAM SW OUT] camera switching signal output terminal When a sequential switcher is connected, this terminal outputs camera switching timing control signals. For details, refer to page 52.