JVC SR-9168U SR-9168U Timelapse Recorder Instruction Manual (633KB) - Page 19

5 SETTING OF THE FUNCTION MENU SWITCHES 5-2 Contents of the Function Menu Switches Screens VTR mode 1 setting VTR mode 2 setting [ ]: Factory setting Items INDEX SEARCH Set values [OFF] ON CAMERA SW [OFF] 1 FIELD 1 FRAME TAPE END BUZZER [OFF] ON WARNING BUZZER [OFF] ON SUMMER TIME [OFF] ON TERMINAL SEL 1 [SERIES] EXT C.ADJ TERMINAL SEL 2 [WARN.] REC REC REMAIN [OFF] 180S 360S Function Enables or disables the Index Search function. OFF : The index search function is disabled. ON : When an alarm-recorded tape is put in the FF or REW Shuttle Search mode, the VCR searches for the nearest recorded index code (VISS signal) and engages playback at the indexed position. When an alarm-recorded tape is fast-forwarded or rewound, the VCR searches for the nearest index code and enters the Stop mode at the indexed position. Sets the camera switching interval for output to an external sequential switcher during recording. OFF : No camera switching signal is output. 1 FIELD : Set to this position to switch the camera every 1 field. 1 FRAME: Set to this position to switch cameras every 1 frame. Turns the Tape End buzzer on or off. OFF : The buzzer does not sound at tape end. ON : When the tape reaches the position set with the menu function switch during recording (tape end, or 3 minutes or 6 minutes before the tape ends during 6H mode ), a buzzer sounds. To stop the buzzer sound, press the [REW] button, [EJECT] button or [POWER] button. When the mode is changed, the buzzer sound stops. Turns the warning buzzer on or off. OFF : The buzzer does not sound. ON : The buzzer sounds. Turns summer time compensation on or off. OFF : Clock is not adjusted for summer (daylight saving) time. ON : Clock is adjusted for summer (daylight saving) time. Select the signal to be input or output to the [SERIES/CLOCK IN·OUT] terminals on the rear panel. SERIES : Set to this position to input or output a series recording signal. EXT : Set to this position to start or stop the recording with the VCR activation signal input from an external control device. C.ADJ : Set to this position to input or output a clock reset signal. Select the signal output from the rear panel's [WARNING/REC OUT] terminal. WARN. : Set to this position to output a warning signal. The warning signal is output if an abnormality occurs in tape transport or mechanism operation. REC : Set to this position to output a recording mode signal (+12 V) in the Record mode. Sets the timing to process tape end before the actual tape end. This menu switch setting is effective in the 6H to L30H Record modes. For the 48H to 240H modes, set with . The following operations are executed at the timing set with this menu switch. • The tape end signal is output from the rear panel's [TAPE END] terminal. • The series recording signal is output from the rear panel's [CLOCK/SERIES OUT] terminal (with the TERMINAL SEL 1> function menu switch set to "SERIES"). • The tape end buzzer sounds (with the function menu switch set to "ON"). • "End" is shown on the counter display. The set values (180S/360S) are for the 6H mode. The relation between the recording mode and the recording time is shown below. Setting OFF 180S 360S 6H Tape end 3 minutes 6 minutes Record modes L18H L30H Tape end Tape end 9 minutes 15 minutes 18 minutes 30 minutes These values should be used as a reference only. Actual values may differ depending on the tape used. 19