JVC SX50M Instruction Manual - Page 14

ENGLISH Adjusting the sound You can adjust the sound characteristics to your preference. 1 Select the item you want to adjust. Each time you press the button, the adjustable items change as follows: 2 Adjust the setting. To increase the level or turn on the loudness To decrease the level or turn off the loudness Tone level indicator changes as you adjust the bass or treble. BAS (bass) VOL (volume) TRE (treble) LOUD (loudness) FAD (fader) BAL (balance) Ex. 1: When you adjust "TRE" (treble) Indication To do: Range BAS*1 Adjust the bass. -06 (min.) | +06 (max.) TRE*1 Adjust the treble. -06 (min.) | +06 (max.) FAD*2 Adjust the front and rear speaker balance. R06 (Rear only) | F06 (Front only) BAL Adjust the left L06 (Left only) and right speaker | balance. R06 (Right only) LOUD*1 Boost low and high frequencies to LOUD ON produce a well- | balanced sound LOUD OFF at low volume level. VOL*3 Adjust the volume. 00 (min.) | 50 (max.) Ex. 2: When you turn on the loudness 3 Repeat steps 1 and 2 to adjust the other items. To reset each sound mode to the factory settings, repeat the same procedure and reassign the preset values listed in the table on page 13. *1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including "USER." *2 If you are using a two-speaker system, set the fader level to "00." *3 Normally the control dial works as the volume control. So you do not have to select "VOL" to adjust the volume level. 14