JVC TH-M45 Instructions - Page 12

Getting started Connecting the FM and AM antennas Make sure the antenna conductors do not touch any other terminals, connecting cords and power cords. This could cause poor reception. % AM loop antenna Setting up supplied AM loop antenna Attach the AM loop to its base by snapping the tabs on the loop into the slot on the base. If reception is poor Connect an outdoor single vinyl-covered wire antenna (not supplied) to the AM EXT terminal. (Keep the AM loop antenna connected.) • Twist together both wires. AM loop antenna Outdoor single vinyl-covered wire antenna (not supplied) If the antenna cord is covered with the insulation coat, twist and pull the insulation coat off and remove. % FM antenna Connecting supplied FM antenna Center unit Connecting AM loop antenna Center unit Extend the supplied FM antenna horizontally. Press and hold down the terminal clamp. Insert the antenna cord. Release finger from the clamp. If reception is poor Connect an outdoor FM antenna with standard type (75 C coaxial) connector. Outdoor FM antenna (not supplied) Outdoor FM antenna cord (not supplied) NOTE • Disconnect the supplied FM antenna before attaching a 75 C coaxial connector (the kind with a round wire going to an outdoor antenna). • We recommend that you use coaxial cable for the FM antenna as it is well-shielded against interference. • Turn the loop antenna until you have the best reception. 9