JVC TH-M45 Instructions - Page 30

Tuner operations You can browse through all the stations or use the preset function to go immediately to a particular station. IMPORTANT Before using the remote control for the following operation; 1 Set the remote control mode selector to AUDIO. 2 Press FM/AM. Remote control mode selector Manual tuning On the remote control: 1 Press FM/AM repeatedly to select the band. Each time you press the button, the band alternates between FM and AM. The selected band appears on the display window, then the last received station appears. Example: When AM is selected After a few seconds Number buttons 2 Press TUNING ª or TUNING · repeatedly until you find the frequency you want. When you hold down the button until the system starts searching for stations and then release it, the system stops searching automatically when a station of sufficient signal strength is tuned in to. • TUNING ª: Increases frequency. • TUNING ·: Decreases frequency. NOTE • When a station of sufficient signal strength is tuned in, the TUNED indicator lights on the display window. • When an FM stereo program is received, the ST indicator lights on the display window. Preset tuning Once a station is assigned to a channel number, the station can be quickly tuned in. You can preset 30 FM and 15 AM stations. 7 To preset the stations NOTE Before you start operation; • There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 2 again. 1 Tune in the station you want to preset. • For the detailed procedure, see "Manual tuning". • If you want to store the FM reception mode for an FM station, select the reception mode you want. See "Selecting the FM reception mode" (A pg. 28). 27