JVC TK-C215VP4U Instructions - Page 21

Setting the switches Remove the dome cover, followed by setting the video image switches. 1. Removing the dome cover Remove the dome cover by unfastening the 3 fastening screws using the wrench supplied. Memo: ● The dome cover and base are connected with fall prevention wire. Mounting the base Remove the camera unit from the base and mount the base to the ceiling or wall. When mounting to a wall, follow the procedures by replacing areas indicated as [ceiling] by [wall] accordingly. Setup Drill mounting holes (R30 mm, 1 1/8 inch) using the template supplied when necessary. R30 mm (1 1/8 inch) Fall Prevention Wire Wrench (Supplied) Coaxial Cable Approx. 100 mm (37/8 inch) Power Supply Wire (AC 24 V only when heater is in use) 2. Removing the inner dome The inner dome is fastened using lugs at 3 different positions. Grasp the inner dome and remove it from the lugs. Note: ● Before touching the camera unit, make sure to touch the metal surface of the [MONITOR] terminal to discharge any static electricity from your body. Static electricity may cause the camera to malfunction. 3. Setting the switches Set the switches for video images. (A Pg. 12) 1. Removing the camera unit from the base A Unfasten the 2 fastening screws from the camera unit using a screwdriver. B Press the 2 lugs inwards to remove the camera unit from the base. A B Lug(x 2) Camera Inner Dome 2 Base Lug(x 3) 3 LL PHASE 1 2 O N2 3 4 4 5 6 WHT. 7 BAL. 8 17