JVC TM-H1950CGU Instruction Manual - Page 5

CONTROLS AND FEATURES FRONT VIEW 1 15 CHROMA CONTRAST VOLUME/SELECT MENU UNDER COLOR BLUE SCAN OFF CHECK ASPECT A B C SLOT D PHASE BRIGHT INPUT SELECT POWER TM-H1950CG CHROMA CONTRAST VOLUME/SELECT PHASE BRIGHT MENU UNDER COLOR BLUE SCAN OFF CHECK ASPECT A B C SLOT D INPUT SELECT POWER 23 4 (Front view of TM-H1950CG shown) 1 Tally lamp Lights when the tally control signal is ON. The tally control signal is input through the REMOTE (external control) remote terminal. For details, refer to Page 18. 2 Chroma/Phase button [ CHROMA/ PHASE] Press this button to activate the picture color density adjustment mode or picture hue adjustment mode. Each time you press the button, the adjustment item changes. Picture color density f Picture hue Adjust the value with the VOLUME/SELECT buttons 4. Also used as a control button in the menu function mode. 3 Contrast/Brightness button [CONTRAST / BRIGHT ] Press this button to activate the picture contrast adjustment mode or picture brightness adjustment mode. Each time you press the button, the adjustment item changes. Picture contrast f Picture brightness Adjust the value with the VOLUME/SELECT buttons 4. Also used as a control button in the menu function mode. 4 Volume/Select buttons [VOLUME/SELECT - +] Adjusts the speaker volume. Also used as a control button in the menu function mode. 5 Menu button [MENU] Displays and disappears the screen. Pressing the CHROMA/PHASE button 2 with the Menu button depressed will display the screen. 6 Under Scan button [UNDER SCAN] Reduces the screen size to display the entire image. Press the button again to cancel Under Scan. When selected, the Under Scan button lights. 7 Color Off button [COLOR OFF] Cuts color signals to display a black and white image. Press the button again to restore the original color. When selected, the COLOR OFF button lights. Note: ● This function is invalid with RGB input. 5 6 7 8 9 10 11 12 13 14 8 Blue Check button [BLUE CHECK] Cuts red and green signal components. Only blue signal components are shown. Press the button again to restore the normal image. When selected, this button lights. 9 Aspect button [ASPECT] Press this button to change the aspect ratio from 4:3 to 16:9. 10 Input A (VIDEO) button [INPUT SELECT A] Selects the video and audio signals input to the VIDEO A * and AUDIO A q terminals on the rear panel. The button lights when selected. 11 Input B (VIDEO Y/C) button [INPUT SELECT B] Selects the video and audio signals input to the VIDEO B ( or VIDEO B (Y/C) ) and AUDIO B w terminals on the rear panel. The button lights when selected. Note: ● The VIDEO B terminals include a video terminal (BNC connector) and a Y/C terminal (mini-DIN 4-pin connector). The Y/C (S-video) terminal has priority. 12 Input C/D (Slot) buttons [INPUT SELECT C/D (SLOT)] Selects the signals to be input via the input cards installed in the rear panel card slots. C, D: Selects the image from the input card in the slot. For details on input connectors and using the INPUT SELECT button, refer to page 7. 13 Power indicator Unlit : The main power is OFF. Orange : The main power is ON, but the monitor's power is OFF (in the stand-by mode). Green : The main power is ON, and the monitor's power is ON (in the normal operation mode). 14 Power switch [POWER ] Press the power switch to turn the monitor's power ON or OFF when the main power is ON. Note: ● When RUSH DELAY is set to SLOW, it takes about three seconds before power is actually supplied after the power switch is pressed. 15 Speaker A built-in speaker is located inside the right side panel when the monitor is viewed from the front. 4