Jenn-Air JES1750FS Installation Instruction - Page 23

6. Unscrew the metal cover and unscrew the blue regulator cap. Keep the washer in place. A A B C A. Metal cover B. Washer C. Blue regulator cap 7. Flip the blue regulator cap over and screw it back into the metal cover. A B A. Natural gas position B. LP gas position 8. Screw the metal cover securely back into place. Do not overtighten. To Convert Surface Burners (Natural Gas to LP Gas) 1. If installed, remove the burner grates. 2. Remove the burner caps. 3. Remove the burner base. B C D A A. Igniter electrode B. Burner cap C. Gas tube opening D. Burner base 4. Apply masking tape to the end of a 9⁄32" (7 mm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside. AB D C A. Igniter electrode C. Orifice spud holder B. Orifice spud D. Screws 5. Remove the orifice spuds shipped in the literature package in the oven. Gas orifice spuds are stamped with a number, marked with 1 or 2 color dots, and have a groove in the hex area. Replace the Natural gas orifice spud with the correct LP gas orifice spud. A A. LP groove Refer to the following chart for correct LP gas orifice spud ratings and to spud holder card for proper placement. LP Gas Orifice Spud Chart for Surface Burners Burner ID Rating/Type Color Size (mm) Number Placement 15,000 BTU/ Silver 1.05 Stacked* Black/ 0.32 Orange L105 LF L32 14,200 Silver 1.05 BTU/ Ultra/ Stacked* L105 LF/RF 8,000 BTU/ Red/ 0.85 Semi Orange L85 RR/CTR 5,000 BTU/ Red/ 0.65 Auxi Blue L65 LR 1,200 BTU/ Stacked/ Simmer* Black/ 0.32 Orange L32 LF (Simmer) *Not in all kits/models. NOTE: Refer to the model/serial/rating plate located on the oven frame behind the top right-hand side of the oven door for proper sizing of spuds for each burner location. 6. Place Natural gas orifice spuds in the orifice spud bag. IMPORTANT: Keep the Natural gas orifice spuds in case of reinstallation with Natural gas. 7. Replace the burner base. 8. Replace burner cap. 9. Repeat steps 1 to 7 for the remaining burners. Complete Installation (Natural Gas to LP Gas) 1. Refer to the "Make Gas Connection" section for proper connection of the range to the gas supply. 2. Refer to the "Electronic Ignition System" section for proper burner ignition and operation. 3. Refer to the "Adjust Flame Height" section for burner flame adjustments. IMPORTANT: You may have to adjust the low setting for each cooktop burner. Checking for proper cooktop burner flame is very important. Natural gas flames do not have yellow tips. 4. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. IMPORTANT: Make sure to save the orifices that have just been replaced in the conversion. 23