Jenn-Air JUW24FLECX Use and Care - Page 7
Install Custom Overlay Panel
View all Jenn-Air JUW24FLECX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
When Moving Your Wine Cellar: Your wine cellar is heavy. When moving the wine cellar for cleaning or service, be sure to cover the floor with cardboard or hardboard to avoid floor damage. Always pull the wine cellar straight out when moving it. Do not wiggle or "walk" the wine cellar when trying to move it, as floor damage could occur. 2. Remove the gasket from the corners of the door, pulling gently until the two screws in each corner of the door can be seen. NOTE: The gasket does not have to be removed from the door, only the corners. A Clean Before Using After you remove all of the packaging materials, clean the inside of your wine cellar before using it. See the cleaning instructions in "Wine Cellar Care." Install Custom Overlay Panel IMPORTANT: ■ Create custom overlay panel according to the specifications in the "Custom Overlay Panel" section. ■ Jenn-Air is not responsible for the removal or addition of molding or decorative panels that would not allow access to the appliance for service. Install Custom Panel 1. Open the door completely to 90°. A B A. Screws B. Gasket 90° 3. Remove the four pairs of screws from the door. 4. Using two people, hold the custom overlay panel so that the holes in the back of the panel align with the holes on the door. NOTE: Custom handles that are placed in a different location (see the "Custom Handle (optional)" section) or are not the recommended size (8" [203 mm] or 6¹⁄₄" [160 mm]) need to be installed on the door panel with countersunk holes and installed before the custom overlay door panel has been installed on the wine cellar door. 7