Jenn-Air JUW24FLECX Use and Care - Page 8
Warning
View all Jenn-Air JUW24FLECX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Then, fasten the custom panel to the door using two wood screws (provided in installation kit) at each corner. NOTE: Do not use the same screws that were previously removed. A Door Closing Door Closing Your wine cellar has four leveling legs. If your wine cellar seems unsteady or you want the door to close more easily, adjust the wine cellar's tilt using the instructions below. WARNING A A. M4 x 14 wood screws 6. Press the gasket firmly back into it's original position. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. WARNING Excessive Weight Hazard Use two or more people to move and install wine cellar. Failure to do so can result in back or other injury. 7. For 8" (203 mm) or 6¹⁄₄" (160 mm) custom handles, install the custom handle from the inside/back of the wine cellar door using screws provided with the handle. 2. Move the wine cellar into its final location. 3. Turn the leveling legs to the right to lower the wine cellar, or turn the leveling legs to the left to raise it. It may take several turns of the leveling legs to adjust the tilt of the wine cellar. NOTE: Having someone push against the top of the wine cellar takes some weight off the leveling legs. This makes it easier to adjust the leveling legs. 4. Open the door and check that it closes as easily as you like. If not, tilt the wine cellar slightly more to the rear by turning both front leveling screws to the right. It may take several more turns, and you should turn both leveling legs the same amount. 8