Jenn-Air JVD0303GS Installation Instruction - Page 15
Complete Installation
View all Jenn-Air JVD0303GS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Alternate Blower Configuration NOTE: After establishing the location of the products to be installed, the blower can be configured to support the desired ducting location. Left Discharge Complete Installation 1. Connect cable assembly and ground wire from vent intake to blower motor. See following sequence figures. A A) B Rear Discharge Internal (Non-Ducted) Venting and Right Discharge C D E A. Cable assembly from vent intake B. Remove 3 screw and put aside you will use later C. Tape to be removed later D. Blower / Motor E. Electrical box B) A A. Assemble cable 15
15
Internal (Non-Ducted) Venting and Right Discharge
Left Discharge
Rear Discharge
Complete Installation
1.
Connect cable assembly and ground wire from vent intake to
blower motor. See following sequence figures.
A
B
C
D
E
A. Cable assembly from vent intake
B. Remove 3 screw and put aside you
will use later
C. Tape to be removed later
D. Blower / Motor
E. Electrical box
A
A. Assemble cable
Alternate Blower Configuration
NOTE:
After establishing the location of the products to be
installed, the blower can be configured to support the desired
ducting location.
A)
B)