Jenn-Air JVD0303GS Installation Instruction - Page 3
Installation Requirements
View all Jenn-Air JVD0303GS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed ■■ Tape measure ■■ Marker or pencil ■■ Phillips screwdriver ■■ Pliers ■■ Flat-blade screwdriver ■■ Jigsaw ■■ Level ■■ Caulking ■■ Drill ■■ Aluminum metal duct tape Parts Supplied Check that all parts are included. ■■ Blower housing assembly with electrical box and intake assembly ■■ Grease filter ■■ 2 - Type-A brackets ■■ 4 - Type-B brackets ■■ 7 - Thread cutting screws ■■ Round duct 2-piece telescoping ducts ■■ 1 - Blower assembly duct mounting ring ■■ Foam strip ■■ 1 - Intake Transition Parts Needed For vented installations: ■■ 6" (15.2 cm) round metal ducting. ■■ Jenn-Air® wall cap: Jenn-Air® 6" (15.2 cm) round wall cap with damper ■■ (8) Round or pan head wood and (8) sheet metal screws See the "Assistance or Service" section in your Use and Care manual to order. For non-vented installations: ■■ Recirculation Kit part number W10807915 (See the "Assistance or Service" section in your Use and Care manual to order). a. Recirculation duct housing b. (4) Mounting screws c. (2) Charcoal filters d. Recirculation housing cover e. (2) Mounting screws - cover f. Duct extension g. (4) Mounting screws - duct extension For non-vented installations (recirculation only): ■■ 1-6" (15.2 cm) round 90 degree elbow and 1-6" (15.2 cm) round to 3Z\v" x 10" (8.3 cm x 25.4 cm) transition and 1- 3Z\v" x 10" (8.3 cm x 25.4 cm) elbow. ■■ Plywood Pedestal to raise blower mounting. See "Product Dimensions" section for detail non-vented installation. ■■ For side cabinet discharge a 31/4" x 10" (8.3 cm x 25.4 cm) straight duct will also be required. Check local codes. Check existing electrical supply. See the "Electrical Requirements" section. It is recommended that all electrical connections be made by a licensed, qualified electrical installer. Location Requirements IMPORTANT: Observe all governing codes and ordinances. When installing the downdraft vent, use the minimum dimensions given. ■■ Use the countertop opening dimensions that are given with these Installation Instructions. Given dimensions are minimum clearances and provide 0" (0 cm) clearance. ■■ The model/serial/rating label is located on the front face of the electrical junction box cover. A A. Model/serial/rating label location ■■ Grounded electrical supply is required. See the "Electrical Requirements" section. ■■ If cabinet has drawers, drawers will need to be removed and drawer fronts installed on front of cabinet. NOTE: The exhaust system is for outside venting. For non-vented (recirculating) installation, see "Recirculation: Nonvented (Recirculating) Installations Only" in the "External Venting Dimensional Planning" section. Recirculating Kit part number W10807915 is available from your dealer or an authorized parts distributor. IMPORTANT: An under-counter built-in oven cannot be installed under this product. 3