Jensen PCR2500CS Owners Manual - Page 5

PCR2500 OPERATING INSTRUCTIONS 1 On-Off Switch/Volume Control Rotate the ON/VOL knob (1) to the right to turn the unit on. Continue rotation until desired volume level is obtained 2 AM/FM Band Selector Press the AM/FM button (2) to change the radio band from AM to FM. FM broadcasts will be received with the switch in the in position, and AM broadcasts will be received with the switch in the out position. 3 Manual Tuning Control Rotate the TUNING knob (3) to the left or right to select the desired radio station. When tuning in a station, always adjust the control so that you are receiving the full signal and are on the center of the broadcast frequency. If the radio is not on frequency, you could experience noise and reception problems. The dial pointer will move along the dial to indicate the frequency to which you are tuned. 4 FM Local/Distant Selector This selector switch is incorporated to allow maximum reception in both weak and strong "FM" signal areas. For normal reception conditions and when receiving a wide range of signals including weak or distant stations, the switch should be set to the in position (DX), which will allow maximum signal to the receiver. When in an extremely strong (local) signal area, set the switch to the Local (LOC) setting (out position). This will eliminate weak signals and suppress overly strong signals so as to avoid overloading the receiver input. When moving out of the strong signal area, return the switch to the DX setting (in position). NOTE: The local/distant selector only affects "FM" signals, and will have no effect on "AM" reception. 5 Cassette Door Hold the cassette with the exposed tape edge to the right and insert it into the cassette door. Depress fully until the cassette is engaged and begins playing. NOTE: Observe the cassette operation cautions in the Care and Maintenance section of this manual. 1 2 54 ON/VOL FM 88 94 98 103 106 108 MHz DX AM 54 60 70 80 100 130 170 x10KHz LOC FF AM / FM / CASSETTE PCR2500 3 TUNING 5