Jensen POWER 760 Operation Manual - Page 8

POWER Amplifiers Speaker Wiring The Speaker Wiring diagrams illustrate options for connecting one or two speakers. Observe the proper speaker polarity. NOTE: Power amplifiers can drive speakers with a nominal impedance range of 2~ 4-ohms. For maximum power, configure your speakers for a nominal 2-ohm load. Power 400/880 Two Speakers 4 ohm nominal One Subwoofer 4 ohm nominal NOTE: Do not overlook the use of the proper gauge speaker wire. The Power series of amplifiers require a minimum of 12-gauge wire. Power 900/1050 Two Subwoofer One Subwoofer SPEAKER OUTPUT SPEAKER OUTPUT -- + + -- + + SPEAKER OUTPUT + LEFT - + RIGHT BRIDGED MODE X-OVER MONO STEREO FULL HPF LPF Tri-Mode SPEAKER OUTPUT + LEFT - + RIGHT BRIDGED MODE X-OVER MONO STEREO FULL HPF LPF 4 ohm 4 ohm 4 ohm nominal L Inductor X-OVER FULL HPF LPF C Capacitor SPEAKER OUTPUT + LEFT - + RIGHT BRIDGED C L 4 ohm nominal 6