Kenmore 2029219 Use and Care Manual - Page 16

MOTOR SAFETY FILTER CLEANING 1 , WARNING Electrical Shock Hazard Turn off and unplug vacuum cleaner from electrical outlet. Do not operate the vacuum cleaner without the motor safety filter. Be sure the filter is dry and properly insta!led to prevent motor failure and/or electrical shock., Check motor safety filter occasionally and clean when dirty.. Io Remove the bag as outlined in the BAG CHANGING section 3. Wash filter in warm soapy water, rinse, then d_. Do not clean in dishwasher or install while damp,, _-.4_'_.___ . ___ ._r\ Ji _\_ _: ._. _._!_ _pu_,_ae_rr/-" 4sl.idRinegplaitcbeacthke infitloter by peace under the ribs in the bag cavity Tuck illter in so that it fits com- pletety under the rub- ber retainer 5o Replace the bag as outlined in the BAG CHANGING section. Re_er_ _: 2oLift the rubber retainer and pult out motor safety filter as shown EXHAUST FILTER CHANGING WARNING Fire andlor Electrical Shock Hazard Do not operate with a clogged exhaust filter or without the exhaust filter or exhaust filter cover installed_ 2oPull the exhaust filter cartridge up and out from the rear of the canister.. HEPA EXHAUST FILTER The exhaust filter cartridge must be replaced when dirty. Replace the filter when the entire surface area is covered evenly. The filter CANNOT be washed as it will lose its dust trapping ability. NOTE: See PARTS AND FEATURES for Exhaust Filter number 1. Pule out and up on the exhaust filter cover to remove from the canister and lay aside. 3.. Replace exhaust filter cartridge Place the new filter cartridge into the canister with the foam seal facing down towards the canister Exhaust Tabs &. Replace the exhaust filter cover by placing the 'two tabs on the filter cover into the slots on the canister and rotate into place until it snaps closed 16