Kenmore 2621 Owners Manual - Page 13

Canister Care - canister vacuum parts

Page 13 highlights

CANISTER CARE For best cleaning results, the dust bag should be changed often. NOTE: See PARTS AND FEATURES for Bag Number. 1. Unplug cord from wall outlet. 2. Remove hose from canister. 3. Pull hood release out and up, then lift canister hood. 4. Disengage cardboard tab from red bag mount by pulling away and lifting up. 5. Pull bag out of the red bag mount. Safety Red Bag Mount 6. Check the motor safety filter and replace if necessary. 7. The red bag mount will flip forward after removing bag. This will prevent the hood from closing until a new bag is installed. Note: DO NOT bend or crease the middle of the cardboard when installing the bag into the bag mount slots. 8. Rotate red bag mount down and install bag into slots per illustration, pushing down until the cardboard tab locks into p?sition and the holes align. Tuck the bag securely into the bag cavity so that none of it is able to be pinched by the hood. 9. Close and latch canister hood. 10. Reinstall hose. 11. Plug cord intowall outlet. CAUTION NEVER REUSE A DUST BAG.Very fine materials, such as carpet freshener, face _owder, fine dust, plaster, soot, new car_et lint, etc. can clog the bag and cause t to burst before it is full and may cause damage to vacuum cleaner motor. Change bag more often when vacuuming these materials. 1. Unplug cord from wall outlet. DO NOT drip water on vacuum cleaner. 2. Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry. Wipe dry after cleaning. 3. To reduce static electricity and dust buildup, wipe outer surface of vacuum cleaner and attachments. CAUTION Do not use attachments if they are wet. Attachments used in dirty areas, such as under a refrigerator, should not be used on other surfaces until they are washed. They could leave marks. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

CANISTER CARE
For best cleaning
results,
the
dust bag
should
be changed
often.
NOTE:
See
PARTS
AND
FEATURES
for
Bag Number.
1. Unplug cord
from
wall outlet.
2.
Remove
hose
from canister.
3. Pull
hood
release
out and up, then lift
canister
hood.
4.
Disengage
cardboard
tab
from
red bag mount
by
pulling
away and
lifting
up.
5.
Pull bag out of
the red bag mount.
Safety
Red Bag
Mount
6.
Check
the
motor safety
filter and
replace
if
necessary.
7.
The red bag mount will flip forward
after
removing
bag.
This
will prevent
the hood
from closing
until a new bag
is
installed.
Note:
DO NOT bend
or crease
the middle
of the cardboard
when
installing
the bag
into the bag mount
slots.
8.
Rotate
red bag
mount
down and
install
bag into slots
per illustration,
pushing
down until
the cardboard
tab
locks into p?sition
and the holes align.
Tuck the bag
securely
into the bag cavity
so that none of it
is able to be pinched
by the hood.
9.
Close
and latch canister
hood.
10. Reinstall
hose.
11.
Plug cord
into
wall outlet.
CAUTION
NEVER
REUSE
A DUST
BAG.Very
fine
materials,
such
as carpet
freshener,
face
_owder,
fine dust, plaster,
soot,
new car-
_et
lint, etc. can clog the bag and cause
t to burst before
it is full and may cause
damage
to vacuum
cleaner
motor.
Change
bag more
often when
vacuum-
ing these
materials.
1.
Unplug
cord from
wall
outlet.
DO
NOT
drip water
on vacuum
cleaner.
2.
Clean
exterior
using a clean,
soft cloth
that has been dipped
in a solution
of mild
liquid
detergent
and water,
then wrung
dry.
Wipe
dry
after cleaning.
3. To reduce
static
electricity
and dust
build-
up, wipe
outer surface
of vacuum
cleaner
and attachments.
CAUTION
Do not use attachments
if they
are wet.
Attachments
used in dirty
areas,
such
as under
a refrigerator,
should
not
be
used on other
surfaces
until they are
washed.
They could
leave marks.
13