Kenmore 2621 Owners Manual - Page 14

IbWARNING Electrical Shock Hazard Unplug power cord from electrical outlet. Do not operate the vacuum cleaner without the motor safety filter. Be sure the filter is dry and properly installed to prevent motor failure and/or electrical shock. MOTOR SAFETY FILTER ELECTROSTATIC This filter must be replaced when dirty, it should be replaced regularly depending on use conditions. The filter CANNOT be washed as it will lose its dust trapping ability. NOTE: See PARTS AND FEATURES for Filter Number. 1. Remove the bag as outlined in the BAG CHANGING section. 2. Lift the rubber retainer and pull out motor safety filter as shown. 3. Replace the filter, white side out, by sliding it back into place under the ribs in the bag cavity. Tuck filter in so that it fits completely under the rubber retainer. 4. Replace the bag as outlined in the BAG CHANGING section. WARNING Exhaust_ Filter _ _ 2. When the becomes dirty, remove it by pulling _ stxrhaaiguhstt ufiplt.er EXHAUST FILTER HEPA The HEPA filter must be replaced when dirty. Replace the filter when the entire surface area is covered evenly. The filter CANNOT be washed as it will lose its dust trapping ability. NOTE: See PARTS AND FEATURES for Exhaust Filter Number. 1. Pull out and up on the exhaust filter cover to remove from the canister and lay aside. 3. Place the new filter into the canister with the foam seal down. Tab Slot 14 Exhaust 4. Reinstall the exhaust filter cover by inserting the tab into the slot in the canister. Press firmly to snap _ exhaust filter J cover into place.