Kenmore 27514 Owners Manual - Page 18

To Replace

Get Kenmore 27514 - Canister Vacuum PDF manuals and user guides View all Kenmore 27514 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

TO REPLACE BELT 1, Instaft new belt over motor drive, then over belt path, NOTE: See PARTS AND FEATURES tor \ A;XY "- Drive .o1, \ --\ Path Agitator End Cap for Belt number. i 2. Place agitator assembly back into PowerMate 3, Line up front of cover and base, Rest cover on front edge of base as shown "/_/'///'_ Cover _ _', Base Side Latch 4. Rotate cover l I:" x_ back Press cover firmly until side and rear Rear Latches latches snap into place. Make sure there is no gap between the cover and base 5. Turn PowerMate upside down and replace two (2) cover screws 1. Remove PowerMate cover as shown in BELT CHANGING AND AGITATOR CLEANING section, 2. Push in and turn bulb counterclockwise, then pull out to remove, Push In 3. Push in and turn bulb clockwise, to replace Bulb must not be higher than 15 Watts (130 'Colts) 4. Reinstall PowerMate cover as shown in BELT CHANGING AND AGITATOR CLEANING section NOTE: See PARTS AND FEATURES for Bulb number,, 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
TO REPLACE
BELT
1, Instaft new
belt over
motor drive,
then over
belt path,
NOTE:
See
PARTS
AND
FEATURES
for Belt number.
tor
Drive
\ A;XY
"-
.o1,
\
--\
Path
Agitator
End
Cap
i
2. Place
agitator
assembly
back into
PowerMate
3, Line
up
"/_/'///'_
front of
cover and
base,
Rest
_
cover on
_',
front edge
of base as
shown
Cover
Base
l
I:"
x_
Side
Rear
Latch
Latches
4. Rotate
cover
back
Press
cover firmly
until
side and
rear
latches
snap
into place.
Make
sure there
is no gap between
the cover
and base
5.
Turn PowerMate
upside
down and
replace
two (2) cover screws
1. Remove
PowerMate
cover
as shown
in
BELT CHANGING
AND
AGITATOR
CLEANING
section,
2. Push in and turn
bulb counterclock-
wise,
then pull out
to remove,
Push In
3. Push
in and turn
bulb clockwise,
to
replace
Bulb must
not be higher
than
15 Watts (130 'Colts)
4.
Reinstall
PowerMate
cover as shown
in
BELT CHANGING
AND AGITATOR
CLEANING
section
NOTE:
See PARTS AND
FEATURES
for
Bulb number,,
18