Kenmore 4101 Use and Care Guide - Page 45

General

Get Kenmore 4101 - Elite 30 in. Slide-In Electric Range PDF manuals and user guides View all Kenmore 4101 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

General Care & Cleaning (cont'd) Removing and Replacing Warmer (Warm & Ready TM) Drawer Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer. To Remove Warmer Drawer: 1. _ Turn power off before removing the warmer drawer. 2. Open the drawer to the fully opened position. 3. Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Figure 1). 4. Pull the drawer away from the range. To Replace Warmer (Warm & Ready TM) Drawer: 1. Pull the plastic slider to the front of the glide slots on each side of the drawer cavity (See Figure 2). 2. Align the glide on each side of the drawer with the drawer cavity glide slot. 3. Push the drawer into the drawer cavity until glide levers "click" (approximately 2"). If you do not hear the glide levers "click" or the drawer does not feel seated remove the drawer and repeat steps 1 thru 3. Note: The Warmer Drawer will NOT operate while in the "Self-Clean" and "Oven Lockout" modes Pull up lever with finger Pull down lever Right Glide with finger Figure 1 Figure 2 Changing the Oven Light Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during the self-cleaning cycle. High temperature will reduce lamp life. The interior oven light will turn on automatically when the oven door is opened. il // The oven light may be turned on when the door is closed by using the oven light switch located on the control panel. On a self clean oven the lamp is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE. To replace the light bulb: CAUTION: BE SURE OVEN IS COOL 1. Turn the power off at the main source. 2. Wear a leather-faced glove for protection against possible broken glass. 3. Replace bulb with a 40 watt appliance bulb only. 4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield. 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
General
Care & Cleaning
(cont'd)
Removing
and
Replacing
Warmer
(Warm
& Ready
TM)
Drawer
Electrical
Shock Hazard can occur and result
in serious injury or death. Disconnect
appliance
from electric
power
before cleaning and servicing
the warmer drawer.
To Remove
Warmer
Drawer:
1.
_
Turn power off before removing
the warmer drawer.
2.
Open the drawer to the fully opened
position.
3.
Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (See Figure 1).
4.
Pull the drawer
away from the range.
To Replace
Warmer
(Warm
& Ready
TM)
Drawer:
1.
Pull the
plastic slider
to the front
of the glide slots on each side of
the drawer cavity (See Figure 2).
2.
Align the glide on each side of the drawer with the drawer cavity glide
slot.
3.
Push the drawer
into the drawer cavity until glide levers "click"
(approximately
2"). If
you
do not hear the
glide
levers
"click"
or the
drawer
does not feel seated
remove
the drawer
and repeat
steps
1
thru
3.
Note: The Warmer Drawer will NOT operate while in the "Self-Clean"
and
"Oven Lockout"
modes
Pull up lever
with finger
Pull down lever
with finger
Figure
1
Right Glide
Figure
2
Changing
the
Oven
Light
il
//
Be sure the oven is unplugged and all parts are COOL before replacing the oven
light bulb. Do not turn the oven light on during the self-cleaning
cycle. High temperature
will
reduce lamp life.
The interior oven light will turn on automatically
when the oven door is opened.
The oven light may be turned on when the door is closed by using the oven light switch
located on the control panel.
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS
GLASS
SHIELD
MUST BE IN
PLACE WHENEVER
THE
OVEN IS IN USE.
To replace
the
light
bulb:
CAUTION:
BE SURE OVEN
IS
COOL
1. Turn the power off at the main source.
2.
Wear a leather-faced
glove for protection against
possible broken glass.
3.
Replace bulb with a 40 watt appliance
bulb only.
4.
For self-cleaning
oven, press wire holder to one side to release glass shield,
change bulb and be sure to replace glass shield.
45