Kenmore 4280 Installation Instructions - Page 4

DO NOT ground to a gas suppty pipe, DO NOT connect to electrka! power suppJy until appliance is permanendy grounded. Connect the ground wire before turning on the power. Where local codes permit connecting the appJiancegrounding conductor to the neutral (white) wire (see figure 3): 1. Disconnect the power supply. 2. In the circuit breaker, fuse box or junction box, connect appliance and power supply cable wires as shown in figure 3. Cable from Power Supply tf cooktop installation is used in a new branch circuit (1995 NEC), mobile home, recreationaJ vehicle, or where tocal codes DO NOT permit grounding to the neutral (white) wire (see figure 4): 1. Disconnect tile power supply. 2. In the circuit breaker, fuse box or junction box, connect appliance and power supply cable wires as shown in figure 4. Cable from Power Supply /__..___ _White Wire Cable from appliance Figure 3 - S-WIRE GROUNDED JUNCTtON BOX You may not ground the cooktop through the neutral (white} wire if cooktop is used in a new branch circuit installation (!995 NEC), mobile home, recreational vehicle, or where beat codes do not permit grounding to the neutraJ (white) wire. When grounding to the neutral (white} wire is prohibited, you must use a 4-wire power supply cabJe. See Figure 4. Failure to heed this warning may resuk in electrocution or other serious personal injury, /___ _Junction Box Green Wire (Ground) ____ U.L-Listed Conduit Connector Cable from appliance Figure 4 - 4-WIRE GROUNDED JUNCTION BOX tf connecting to a 4-wire power supply cable etectrkal system, the appliance frame connected ground wire MUST NOT be connected to the neutrat wire of the 4-wire eJectricaJ system. NOTE TO ELECTRICIAN: The armored cable leads supplied with the appliance are Ublisted for connection to larger gauge household wiring. The insulation of the leads is rated at temperatures much higher than temperature rating of household wiring. The current carrying capacity of the conductor wire is governed by tile temperature rating of tile insulation around the wire, rather than tile wire gauge alone.