Kenmore 6962 Installation Instructions - Page 4

Power Supply Cord DirectWire Fire Hazard Use t0 gauge somid copper Use a UL approved Disconnect strain wire, retief, power before making emectdcamconnections. Connect neutral wire (white or center wire) to center terminal (simver). Ground wire (green or bare wire) must be connected green ground connector, Connect remaining 2 terminals (gold)= Securely tighten 2 suppmy wires to remaining to aH emectrical connections. Failure to do so can result in death, fire, or electrica_ shock. 3. Assemble a 3/, in. (1,9 cm) UL approved strain relief (UL marking on strain relief) into the hole below the terminal block opening. Tighten strain relief screws just enough to hold the two clamp sections together. Put power supply cord through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. 5 6 Now complete installation following instructions of electrical connection: 4-wire (recommended) !. 2. 3. 4. 5. 6. Terminal block cover External ground connector Center, silver-colored terminal block screw Hold-down screw Neutral grounding wire (green/yellow) Hole below terminal block opening for your type 3-wire (if 4-wire is not available)