Kenmore 6962 Installation Instructions - Page 5

Electrical Connection Options If your home has: And you will be connecting to: A UL listed, 120/240 volt amp., dryer power supply minimum, 30 cord* A fused disconnect or circuit breaker box* A UL listed, 120/240 volt amp., dryer power supply minimum, 30 cord* 3-wire direct A fused disconnect or circuit breaker box* Go to Section: 1. 2. Remove center terminal block screw. Remove appliance ground wire (green with yellow stripes) from external ground connector screw. Fasten it under center, silver-colored terminal block screw. 4-wire receptacle (NEMA type 14-30R) 4-wire connection: Power Supply --j_ 4-wire direct Cord 4-wire connection: Direct Wire ...1, External ground connector - Dotted line shows position of NEUTRAL ground wire before being moved to center terminal block screw 2. Center silver-colored terminal block screw 3. Green/yellow wire of harness 3-wire receptacle (NEMA type 10-30R) 3-wire connection: Power Supply 3. 4. 3-wire connection: Direct Wire Cord Connect ground wire (green or bare) of power supply cord to external ground conductor screw. Tighten screw. Connect neutral wire (white or center wire) of power supply cord under center screw of the terminal block. ...) I'_' I * If local codes do not permit the connection of a framegrounding conductor to the neutral wire, go to "Optional 3-wire connection" section. 4-wire connection: Power supply cord 2* b J ... 2 IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. 2 _ _ 6 2. wire of power supply cord or bare copper wire 1. Green Externalground connector 3. _ in. (1.9 cm) UL-listed strain relief 4. Center silver-colored terminal block screw 5. Neutral wire (white or center wire) 6. Neutral grounding wire (green/yellow) 5. 6. 7. Connect the other wires to outer terminal block screws. Tighten screws. Tighten strain relief screws. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 3 4 5 7 1.4-wire receptacle (NEMA type 14-30R) 2. 4-prong plug 3. Ground prong 4. Neutral prong 5. Spade terminals with upturned ends 6. _ in. (1.9 cm) UL approved strain relief 7. Ring terminals