Kenmore 6965 Installation Instructions - Page 14

Reversible Super Wide Side-Swing Door ChectkhelevelnesosfthedryerC. hecklevelnesfisrstsideto sidet,henfronto back. C D Ifthedryeirsnotlevelp, ropupthedryerusingawoodblock. Useawrenctho adjustthelegsupordownandcheckagain forlevelness. Youcanchangyeourdoorswingfromaright-sidoepening to aleft-sidoepeningif,desired. Reversible Large Side-Swing Door 1. Place towel (A) on top of dryer to avoid damaging surface. 2. Open dryer door. Remove bottom screws from cabinet side of hinges (D). Loosen (do not remove) top screws from cabinet side of hinges. 3. Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from cabinet. 4. Remove screws attaching hinges to door. 5. Remove screws at top, bottom, and side of door (4 screws). Holding door over towel on dryer, grasp sides of outer door and gently lift to separate it from inner door. Do not pry apart with putty knife. Do not pull on door seal or plastic door catches. 6. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door panel so handle is on the side where hinges were just removed. 1. Place towel (A) on top of dryer to avoid damaging surface. 2. Open dryer door. Remove bottom screws from cabinet side of hinges (C). Loosen (do not remove) top screws from cabinet side of hinges. 3. Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Set door on top of dryer. Remove top screws from cabinet. 4. Use a small, flat-blade screwdriver to gently remove 4 hinge hole plugs (D) on left side of cabinet. Insert plugs into hinge holes on right-hand side of cabinet. 5. Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges. 7= Attach door hinges to dryer door so that the larger hole is at the bottom of the hinge. 8= Remove door strike (E) from cabinet. Use a small, flat-blade screwdriver to gently remove 4 hinge hole plugs (F) on left side of cabinet. Insert plugs into hinge holes on right side of cabinet. 9= Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position door so large end of door hinge slot is over screws. Slide door up so screws are in bottom of slots. Tighten screws. Insert and tighten top screws in hinges. 6= Close door and check that door strike aligns with door catch (B). If needed, slide door catch left or right within slot to adjust alignment. 14