Kenmore 6965 Installation Instructions - Page 7

Style2:Direcwt irestrainrelief • Unscrew the removable conduit connector and any screws from a 3/4" (19 mm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads. A. Removable conduit connector B. Hole below terminal block opening C. Strain relief threads Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. Electrical Connection Options If your home has: And you will be connecting to: Go to Section 4-wire receptacle (NEMA Type 14-30R) (_) A UL listed, 120/240-volt 30-amp, dryer mpoinwimerumsu, pply cord* 4-wire connection: Power supply cord 4-wire direct A fused 4-wire connection: circuit breaker dboisx*connect or Direct Wire 3-wire receptacle (NEMA type 10-30R) (_ A UL listed, 120/240-volt 30-amp, dryer mpoinwimerumsu, pply cord* 3-wire direct (89 mm_ A fused disconnect or cboirxc*uit breaker 3-wire connection: Power supply cord 3-wire connection: Direct Wire * If local codes do not permit the connection of a cabinet-ground conductor to the neutral wire, go to "Optional 3-wire connection" section. 4-wire connection: Power Supply Cord IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. A B F 4. Now complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) CD E G A. 4-wire receptacle (NEMA type 14-30R) B. 4-prong plug C. Ground prong D. Neutral prong E. Spade terminals with upturned ends F. 3/4" (19 mm) UL listed strain relief G. Ring terminals 1. Remove center terminal block screw.