Kenmore 7840 Use and Care Guide - Page 12

2.Replacing Refrigerator Door I_ Right Door • Lower the door onto the middle hinge pin (9). Make sure the door is aligned with the cabinet. • Replace the top hinge (8) installing hinge screws (7) to secure it. " Make sure the gasket on the door is flush against the cabinet and is not folded. Support the door on the handle side while securing hinge. Make sure the door is straight and the gap between the doors is even, • Connect the door switch wire (2). • Tighten the cover screw (1). I_ Left Door • Lower the door onto the middle hinge pin (10). Make sure the door is aligned with the cabinet. • Replace the top hinge (8) installing hinge screws (7) to secure it. • Make sure the gasket on the door is flush against the cabinet and is not folded. Support the door on the handle side while tightening. And make sure the door is straight and the gap between the doors is even. • Insert the water supply tube (4) into the connector tube until you see only one scale mark, (Fully insert the tube over 5/8"(15 mm)). • Install the ground screw (6) and connect the wire harness (5). • Connect the door switch wire (2). - Tighten the cover screw (1). , Disassembly : 1. Pull out tube while pressing collets and disassemble it. Collet Insert • Assembly : • Blue to Blue _ • Wonhnietectintgo Wthuibtee color l 1. Insert tube until you can see only one line. 2. After inserting, pull out tube to check if it's properly inserted. \ 12