Kenmore 7972 Installation Instructions - Page 5

MOBILE HOME INSTALLATION 1.Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. 2.If dryer is exhausted through the floor and area beneath the mobile home is enclosed, the exhaust system MUSTterminate outside the enclosure with the termination securely fastened to the mobile home structure. 3. Refer to page 3 for other important venting requirements. ii i 4.When installing a gas dryer into a mobile home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. _iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii 5. Installation MUSTconform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32- 80) or when such standard is not applicable, with American National Standard for Mobile Homes. In Canada, the CSA Z240 is applicable. _1__ The laundry center is designed under ANSI Z 21.5.1for HOME USE only. UNPACKING 1. Using the four shipping carton corner posts (two on each side), carefully lay the laundry center on its left side and remove foam shipping base. Excessive weight. Use two or more people to move Laundry Center. 2. Using a ratchet with 3/8 inch (0.96 cm) socket, remove the mechanism shipping bolt and plastic spacer block from the center of the base. NOTE: If the laundry center is to be transported at a later date, the tub blocking pad, shipping bolt, and plastic spacer block should be retained. 3. Return laundry center to an upright position. 4. Remove: (a) foam tub blocking pad. (b) foam shipping blocks from rear of unit. (c) tape from dryer door. (d) foam dryer support pads. (e) inlet hoses. (f) enclosure package. 5. From the back of the washer, remove the wire shipping clips securing the drain hose and power cord (if equipped). Plastic clamps secure the drain hose to the right side of the washer backsheet. These clamps form a standpipe to prevent water syphoning. DO NOT REMOVE THESE CLAMPS. 6. Carefully move the laundry center to within 4 feet (1.22 m) of the final location to begin the installation. PLASTIC SPACER MECHANL € SHIPPING BOLT FOAM SHIPPING PAD CARTON CORNER POSTS POWER CORD (IF EQUIPPED) DRAIN HOSE