Kenmore 9410 Installation Instructions - Page 4
Range Connection, Opening, Size Chart
View all Kenmore 9410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
2A.Models with Factory Connected Power Supply Cord NOTE: Some models may be equipped with a factory connected three (3) conductor power supply cord. Mobile home installations, new branch circuit installations (1996NEC) or areas where local codes do not permit grounding through neutral require a four (4) conductor power supply cord kit rated at 125/250 volts minimum and marked for use with ranges. See Range Connection Opening Size Chart for cord kit ampere rating information. Terminals on end of wires must be either closed loop or open-end spade lugs with upturned ends. 2B.Models Requiring Power Supply Cord Kit RISK OF FIRE OR ELECTRICAL SHOCK MAY OCCUR IF AN INCORRECT SIZE RANGE CORD KIT IS USED, THE INSTALLATION INSTRUCTIONS ARE NOT FOLLOWED OR STRAIN RELIEF BRACKET IS DISCARDED. Range Connection Opening Size Chart Supply Cord Kit ampere rating information. See serial plate on range for kilowatt rating data. See Serial Plate on Range for KW Rating 120/240 Volts 120/208 Volts Cord Kit Ampere Rating Diameter (inches) of Range connection Opening Permanent Cord Kit Wirinq 8.8-16.5 KW 7.9-12.5 KW 16.6-22.5 KW 12,6-18.5 KW 40/50 tunp 50 Amp 1-3/8 in. 1-3/8 in. 1-1/8 in. 1-3/8 in, 1-1/8" Dia. Knockout (_) 7/8" Dia. _" Hole (See Chart) 4" This appliance may be connected by means of a power supply cord. Only a power supply cord kit rated at 125/250 volts minimum, and marked for use with ranges shall be used. See chart on page 3 for cord kit ampere rating information. Cord must have either three (3) or four (4) conductors. Terminals on end of wires must be either closed loop or open-end spade lugs with upturned ends. Cord must have strain relief clamp. Hole _ (See Chart) Pocket for Cable Mounting Plate See section 4A for 3-wire or section 4B for 4-wire connection. 3. Electrical Connection to Range The rear access cover must be removed. To remove, loosen center screw (one screw) and remove access cover. The terminal blockwill then be accessible. Cover Rear of Range NOTE: Range is shipped from factory with 1-3/8" dia. hole as shown. To use either 7/8" dia. hole or 1-1/8" dia. knockouts: If a different diameter hole is required, please follow the steps below: 1. Using a 1/4" socketdriver, remove eight(8) screwsfrom Rear Wall Shield to release from the unit (as shown). Save the screws for step #7 below. 2. Again usingthe 1/4" socket driver,remove one (1) blunt pointscrew used to secure the Cable MountingPlate to the Rear Wall Shield. Save the screws for step #6. 3. Remove the Cable Mounting Plate from the Rear Wall Shield by sliding the plate out of the pockets. 4. If a 1-1/8"dia. hole isrequired,"punch-out"the knockout. 5. Rotate the plate 180 degrees so that the desired hole is placed on top of the opening located on the bottom flange of the Rear Wal! Shield. 6. Slide the Cable Mounting Plate into the RearWall Shield. Re-secure using the blunt point screw removed from step #2 above. 7. Reassemble the Rear Wall Shield to the unit using eight (8) screws removed from step #1 above. 4