Kenmore 9791 Operating Instructions - Page 3

Cycle Selection - 97912 97962

Page 3 highlights

WASH/RHUSE TEMPERATURE WABM WARM % COLD COLD @ COLD @* Washer Operating Instructions Laundry Center Model 97912/97962 PREWASH P Jr L TO S fY/R7 PI/ ;H _0 S7OP Before Operating Your Washer Read your Washer Owner's Guide. It has important safety and warranty information. It also has many suggestions for best washing results. To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANTSAFETYINSTRUCTIONS inyour Washer Owner's Guide before operating this appliance. 5. If desired, add liquid fabric softenerto fabric softener dispenser. DO NO Tpourfabric softener directly onto wash load. 7. Add laundry load loosely to wash tub. Dry load should not be higher than top of agitator vanes. For best results, DO NOT overload. 8. Select the wash cycle and settings according to type, size and soil level of each load. Operating Steps Read Washing Procedures in your Owner's explains these operating steps in detail. Guide. It 1. Sort laundry into loads that can be washed together. 2. Prepare items for washing. 3. Pretreat stains and heavy soil. 4. Add the measured amount of detergent to wash tub before adding the laundry load. 9. Close lid and pull out Cycle Selector knob to start washer. The washer will not fill with water, agitate or spin with the lid open. To stop the washer, push in the Cycle Selector knob. To change a cycle, push in the Cycle Selector knob and turn it clockwise tothe desired setting. Pull outthe knob to restart the washer. 10. Remove items at end of cycle. Wait about 2-3 minutes for safety lid lock to release. 5. If desired, add liquid bleach to bleach dispenser. DO NOTpour bleach directly onto the load. Printed in U.S.A. Cycle Selection Push in and turn the Cycle Selector knob clockwise to the desired cycle. For best results, follow the washing instructions on the fabric care labels. The Regular, Perm Pressand Delicates cyclesprogress through wash agitation, drain and spin with a spray rinse, rinse agitation, and a spray rinse during the final spin. Regular Cycle This cycle provides up to 15 minutes of normal agitation and a fast spin for most fabrics. Extra Rinse Cyde Use the Extra Rinsecycle after any complete wash cycle when an additional deep rinse may be needed to remove excess detergent and soil. It provides 3 minutes of rinse agitation in cold water, followed by a spray rinse at the selected rinse water temperature during spin. If desired, add liquid fabric softener to the rinse water or use a softener sheet in the dryer. DO NOT pour fabric softener directly onto the load. PIN 137229400 (0906)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

Washer
Operating
Instructions
Laundry
Center
Model
97912/97962
WASH/RHUSE
TEMPERATURE
WABM
COLD
WARM
COLD
%
@
COLD
@*
PREWASH
P Jr L TO S
fY/R7
PI/
;H
_0
S7OP
Before
Operating
Your
Washer
Read your
Washer Owner's
Guide.
It has important safety
and warranty
information.
It also has many suggestions for
best washing results.
To reduce the risk of fire, electric shock, or
injury to persons,read the IMPORTANTSAFETYINSTRUCTIONS
inyour Washer Owner's Guide before operating this appliance.
Operating
Steps
Read
Washing
Procedures
in your
Owner's
Guide.
It
explains these operating
steps in detail.
1.
Sort laundry
into loads that can be washed
together.
2.
Prepare
items
for washing.
3.
Pretreat
stains
and heavy
soil.
4.
Add the measured
amount
of detergent
to wash tub
before
adding
the
laundry
load.
5.
If desired, add
liquid
bleach to bleach dispenser.
DO
NOTpour
bleach directly
onto
the
load.
5.
If desired, add liquid
fabric softenerto
fabric softener
dispenser.
DO NO Tpourfabric
softener
directly
onto
wash
load.
7.
Add
laundry
load loosely
to
wash
tub.
Dry
load
should
not be higher
than top of agitator
vanes. For
best
results,
DO NOT overload.
8.
Select the wash cycle and settings
according
to type,
size and soil
level
of
each
load.
9.
Close
lid
and
pull
out
Cycle Selector
knob
to start
washer.
The washer will not fill with water,
agitate or
spin with the lid open.
To stop the washer,
push in the Cycle Selector
knob.
To change a cycle, push in the Cycle Selector knob and
turn it clockwise tothe desired setting.
Pull outthe knob
to restart the washer.
10. Remove
items at
end
of cycle.
Wait about 2-3 minutes
for safety lid lock to release.
Cycle Selection
Push in and turn the Cycle Selector knob clockwise
to the
desired
cycle.
For
best
results,
follow
the
washing
instructions
on the fabric
care
labels.
The Regular, Perm Pressand Delicates cyclesprogress through
wash
agitation,
drain
and spin with
a spray rinse, rinse
agitation,
and a spray rinse during the final spin.
Regular
Cycle
This cycle provides up to 15 minutes of normal agitation and
a fast spin for most fabrics.
Extra
Rinse
Cyde
Use the Extra Rinsecycle after any complete wash cycle when
an additional
deep rinse may be needed to remove excess
detergent
and soil.
It provides 3 minutes of rinse agitation
in cold water, followed
by a spray rinse at the selected rinse
water temperature
during
spin.
If desired, add liquid fabric softener to the rinse water
or use
a softener
sheet in the dryer.
DO NOT pour fabric softener
directly onto the load.
Printed in U.S.A.
PIN 137229400 (0906)