Kenmore 9802 Installation Instructions - Page 1

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED TECHNiCiAN. iMPORTANT: SAVE FOR THE LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. 1. Clearances and Dimensions a. Provide adequate clearances between the range and adjacent combustible surfaces. b. Location--Check location where the range will be installed. Check for proper electrical supply and the stability of floor. c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level. FRONT TYPICAL CABINET iNSTALLATiON ViEW ° 1' 30" --_ I 30" Minimumto 1" Minimum wail on either - Pit I side of range I "" above 36" height. I t Minimumto 18" ceaitbhienrestisdeon s"#vff 1_13"÷ fMoracxaimbiunmetdsepth f/ FRONT VIEW T 29-7/8"--._i I 25-3/4" Maximum 49" l 36 ± 1/8" 46' X Dooropen "\ \.. 30,,.11"v_-_ _------- 3 01/8 "--------_ O"dearance below cooking top and at rear of range. * 30" minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet; or 24 " minimum when bottom of wood or metal cabinet is protected by not less than 1A"flame retardant millboard covered with not less than no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper. The minimum clearance is O"for the rear of the range. Follow all dimension requirements provided above to prevent property damage, potential fire hazard, and incorrect countertop and cabinet cuts. Avoid locating cabinet storage space above the surface units to eliminate the possibility of cabinets catching on fire, or personal burns from reaching for the cabinets over the heated units. If cabinet storage is to be provided, risk can be reduced by installing a range hood that projects horizontally a minimum of 5" beyond the bottom of the cabinets. Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the appliance. 2. Remove all packing material before connecting the electrical supply to the appliance. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. BACK ViEW _f '-:i:- oe_lectrical outlet ',//_ _- .....l.o..cation are maximum. Cubed area shows ' I / Terminal'_ I where the electricall I I Block [ _/ outlet must be I Location .__ installed for the ',/ ' "_ :'_-_'1range to be flush I'_- 9' _ _ ,, to the wall. /; o ,o,I t "_" _ 3"_ -_:-__v _ Edge important Note to the Consumer Keep these instructions with your Use and Care Guide for future reference. Printed in United States 318201720 (0807) Rev. A