Kenmore 9802 Use and Care Guide - Page 7
Before, Controls, cont'd
View all Kenmore 9802 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Before Setting Surface Controls (cont'd) To Set the Cooktop Lockout Feature _COOKTOP The clock (_ pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being accidentally turned ON. This feature will only lock the cooktop. iNSTRUCTiONS PRESS To turn the Cooktop Lockout Feature ON: 1. BE SURE ALL surface element controls are set to the OFF position. 2. Press and hold _(_ until "CLO" (clock) appears (Figure 1). Continue (_ holding until a second beep sounds (after 3 seconds). If a triple beep sounds instead, check all surface elements and turn them to the OFF position and repeat this step. I_1will appear in the display indicating the cooktop controls and functions are locked out until the cooktop is unlocked (See Figure 2). DISPLAY Figure 1 Figure 2 To turn the Cooktop Lockout Feature OFF: 1. Press and hold (_ until "CLO" appears (Figure 3). Continue holding until a second beep sounds (after 3 seconds). I_1will disappear from the display indicating the cooktop may be used normally (Figure 4). Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop Lockout feature. The cooktop will remain locked until the Self-Clean cycle has completed and the oven door has unlocked. If a power failure occurs after the Cooktop Lockout has been activated, you must turn OFF the Cooktop Lockout feature before being able to use the cooktop features again. Figure 3 Figure 4 ii.i.l i.i........ How the Electronic Surface Element Controls work when the Sabbath feature is ON. When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that all electronic surface element control displays show "Sb". The surface elements can be used even if the Sabbath Feature is on. To turn ON a Surface Element when the Oven Sabbath Feature is active: With the Sabbath feature active, a surface element will not start heating until 15-30 seconds after you turn it on. The heat setting you have turned to will not appear in the display because -Sb,, is showing there. Any adjustment to the heat setting will also take 15 -30 seconds to go into effect. To turn OFF the Surface Element when the Oven Sabbath Mode is active: To shut off the surface element while the Sabbath feature is ON, press the ON/OFF button for that element. The element will immediately turn off without delay. Note: Refer to the Sabbath Feature section.