Kenwood CD-203 User Manual - Page 25
In case of difficulty
View all Kenwood CD-203 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
In case of difficulty CD-206/204/203/DPF-R6010/R4010/R3010 (En) What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or service representative. 25 Operation to reset The microcomputer may malfunction (impossibility to operate, erroneous display, etc.) when the connection cords are unplugged while the unit is ON or due to an external factor. In this case, execute the following method to reset the microcomputer and return it to normal condition. Unplug the power cord from the power socket and plug the power cord into the socket again. ÷ Please be aware that resetting the CD player will erase all stored information and return it to the factory settings. CD player unit Symptom Cause Remedy The unit is not turned ON with the ON/ STANDBY (POWER/ ) switch ON. ÷ Power plug is loosely connected. ÷ With the power plug connected to the switched AC outlet of an amplifier, the power of the amplifier is turned off. ÷ Insert the power plug firmly to the AC outlet. ÷ Turn the amplifier's power ON. There is no sound even when a disc is loaded. ÷ Disc is loaded upside down. ÷ Disc is loose. ÷ Disc is dirty. ÷ Disc is cracked. ÷ Condensation has occurred on the optical lens unit. ÷ Play mode is not entered. ÷ The connection cords are inserted loosely. ÷ Output level is attenuated too low. ÷ Load the disc again with its label side up. ÷ Insert disc properly. ÷ Wipe off the dust on the surface of the disc referring to "Disc handling precautions".¢ ÷ Replace the disc with a new one. ÷ Remove any condensation from the unit by referring to the section entitled, "Caution on condensation". ¢ ÷ Press the 6 key. ÷ Connect all connection cords firmly. ÷ Adjust the output level with OUTPUT key on the remote control unit. 5 Music is interrupted. (Sound is skipped.) ÷ Disc is too dirty. ÷ Disc is cracked. ÷ Oscillation is applied to this unit. ÷ Wipe off the dust on the disc surface referring to "Disc handling precautions". ¢ ÷ Replace the disc with a new one. ÷ Try selecting a place where no strong vibrations occur by changing the installation place, etc. Play begins as soon as the unit is turned ON. ÷ This unit is designed so that play begins automatically when the unit is turned ON if a disc is already loaded. ÷ If automatic play is not required remove the disc from the player before setting the unit to STANDBY mode. Remote control unit Symptom Remote control operation is not possible. Cause Remedy ÷ Batteries are exhausted. ÷ The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle in between. ÷ Replace with new batteries. 8 ÷ Operate the remote control unit within the controllable range. 8 For the U.S.A. CAUTION: Use of controls or adjustment or performance of procedures other than those specified herein may result in hazardous radiation exposure. In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety. KENWOOD CORPORATION 2967-3, ISHIKAWA-CHO, HACHIOJI-SHI, TOKYO, JAPAN KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS NO. 21 CFR 1040.10, CHAPTER I, SUBCHAPTER J. Location: Back Panel