Kenwood DNN990HD Instruction Manual - Page 66

Return to the Top page Setting Up Language setup 1 Touch [SET] of [Language] in the User Interface screen. Language Setting screen appears. 2 Set each item as follows. Select Mode Select the mode to select a language. Easy (Default): Selects a language easily. Advanced: Allows you to select languages for respective items.* Language Select Select a language. * If you select [Advanced] for Select Mode, the following screen appears. Navigation Language Select: Select the language used for navigation. STT: Select the language used for Speech to Text (ST T ). TTS: Select the language used for Text to Speech (TTS). 3 Touch [Enter]. NOTE • To cancel the language setup, touch [Cancel]. ÑÑTouch panel adjustment 1 Touch [Touch] in the System Menu screen. Touch Panel Adjustment screen appears. 2 Follow the instruction on the screen and touch the center of each . GUI Language Select: Select the language used for the GUI and input methods. ASR: Select the language used for voice control function. 130 NOTE • To cancel the touch panel adjustment, touch [Cancel]. • To reset to the initial status, touch [Reset]. ÑÑSecurity setup A red indicator will blink on the unit after the ACC is set to OFF, warning potential thieves. If turned to "ON" (default), the security indicator on the front panel flashes when the vehicle ignition is off. 1 Touch [Security] in the System Menu screen. Security screen appears. 2 Touch [ON] or [OFF] of [SI]. ÑÑEXT SW setup (DNN990HD) Set up the external switch power mode. 1 Touch [EXT SW] in the System Menu screen. EXT SW screen appears. 2 Set each item as follows. Return to the Top page Setting Up ÑÑSetup memory Audio Control, AV-IN SETUP, Camera, and Audio SETUP settings can be memorized. The memorized settings can be recalled at any time. For example, even when the settings are cleared due to replacement of the battery, the settings can be restored. 1 Touch [SETUP Memory] in the System Menu screen. SETUP Memory screen appears. 2 Follow the instruction on the screen. Output Pattern Set the power signal output mode among "Pulse"/"Level". Default is "Pulse". You can set to turn output on/off each time the button on the EXT SW screen is touched. See External Device Control (P.137). Pulse Set Set the pulse signal output time. Outputs 500ms when "1" is set. Increases by 200ms with each step. Up to 100 steps can be set. NOTE • You can enter characters only after you have applied the parking brake. • "Pulse": Generates a single power signal pulse. • "Level": Continues output of high power signal. [Lock] / [Unlock]* Locks or unlocks the AV-IN SETUP, and Audio SETUP settings. Yes Memorizes or recalls the settings. No Cancels the function or memorization. The SETUP Menu screen appears again. * When [Lock] is selected, you cannot change the AV-IN SETUP, and Audio SETUP settings. Also, the locked key mark is displayed under each setting icon in the setup menu. Continued 131