Kenwood DNX9180S Instruction Manual - Page 80
Supplied accessories for, installation, Installation procedure, Connection/Installation
View all Kenwood DNX9180S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Connection/Installation • Do not press hard on the panel surface when 9 installing the unit to the vehicle. Otherwise scars, damage, or failure may result. • Reception may drop if there are metal objects x1 near the Bluetooth antenna. 0 Bluetooth antenna unit ÑÑSupplied accessories for installation 1 x1 2 (Black 1 m) x1 3 (Gray 1 m) x1 4 (3 m) x1 5 (M5 x 8 mm) x6 6 (M5 x 8 mm) x6 7 x1 8 (3.5 m) x1 x1 - x1 = [1] x3 ~ [1] x1 ! [1] x1 @ [1] x1 [1] DNX9180DABS only ÑÑInstallation procedure 1) To prevent a short circuit, remove the key from the ignition and disconnect the ¤ terminal of the battery. 2) Make the proper input and output wire connections for each unit. 3) Connect the speaker wires of the wiring harness. 4) Connect the wiring harness wires in the following order; ground, battery, ignition. 5) Connect the wiring harness connector to the unit. 6) Install the unit in your car. 7) Reconnect the ¤ terminal of the battery. 8) Perform the Initial Setup. See Initial setup (P.9). 80