Kenwood DNX9180S Instruction Manual - Page 86

Connection/Installation ÑÑ3 way speaker system setup NOTE • For speaker system setup, see 3 way speaker system setup (P.67). • For speaker setup and crossover setup, see Speaker/ X'over setup (P.68). • For how to connect speaker wires to terminals other than speaker terminals and Preout terminals, see Connecting the system and external components (P.86) and Connecting wires to terminals (P.85). Subwoofer Preout Mid Range Preout Tweeter Preout When connecting to an external amplifier, connect its ground wire to the car's chassis to avoid damaging the unit. Preout RCA Cable (Sold separately) Power amplifier (optional accessory) Speaker Input White + White/Black To mid range left speaker Gray + Gray/Black Green + To mid range right speaker To tweeter left speaker Green/Black Purple + To tweeter right Purple/Black speaker Speaker impedance: 4-8 Ω ÑÑConnecting the system and external components 14 13 12 11 10 9 87 6 1 2 3 4 5 1 HDMI input Use HDMI cable KCA-HD100 (optional accessory). When you connect the cable to HDMI terminal, remove the fixture. After connecting the cable, put the fixture again. Fixture HDMI connector 2 Accessory @: DAB antenna (DNX9180DABS only) 3 AV Audio output (ø3.5 mini jack) 4 FM/AM antenna input 5 When connecting to an external amplifier, connect its ground wire to the car's chassis to avoid damaging the unit. Rear Audio Preout (Left; White, Right; Red) Front Audio Preout (Left; White, Right; Red) Subwoofer Preout (Left; White, Right; Red) 6 TV tuner remote output 86