Kenwood DNX9180S Instruction Manual - Page 82

Detaching the trim plate, Installation the Digital Radio, antenna DNX9180DABS, CAUTION

Get Kenwood DNX9180S PDF manuals and user guides View all Kenwood DNX9180S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 82 highlights

Connection/Installation ÑÑDetaching the trim plate 1) Detach accessory 7 to the unit. ●●Installation overview The antenna should be installed on the passenger side for safety. ! @ 7 ÑÑInstallation the Digital Radio antenna (DNX9180DABS) #CAUTION • This film antenna is exclusively for use inside the vehicle. • Do not install at the following locations: --Where it may block driver's view --Where it may obstruct operation of safety devices such as air bags --On movable glass surface such as rear hatch --On the side of the vehicle (e.g. doors, front-side windows) --On rear windows • Signal strength will decrease at the following locations: --On IR reflecting glass or where covered with mirror type glass film --Where it overlaps with genuine radio antenna (pattern) --Where it overlaps with window heating wires --When glass that blocks radio signals (e.g. IR reflecting glass, thermal insulation glass) is used • Poor reception may occur: --Due to noise when the windshield wipers, air conditioner, or motor is turned on --Depending on the location of the broadcast station in relation to the vehicle (antenna) • Thoroughly wipe oil and dirt from the pasting surface with the included cleaner (accessory ~). • Do not bend or damage the film antenna (accessory !). • It may not be possible to install on some type of vehicle. • Check the cable routing of the film antenna (accessory !) and amplifier (accessory @) before pasting. 82 Antenna cable (3.5 m) ●●Determining the antenna installation location • The direction of the film antenna (accessory !) changes depending on whether the film antenna is installed on the right side or left side. • Be sure to check the installation location of the film antenna (accessory !) before installing. The film antenna cannot be reattached. • Install the antenna at least 100 mm away from other antennas. • Do not attach the amplifier unit (accessory @) to the ceramic line (black part) around the windscreen, as it will not stick sufficiently. When installing the antenna on the right side Ceramic line (black part) 150 mm @ Earth sheet * 30 mm ! When installing the antenna on the left side Ceramic line (black part) 150 mm 30 mm ! Earth sheet * @ NOTE • *Where the earth sheet of Amplifier (accessory@) can be pasted on the metal part of the front pillar.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
Connection/Installation
82
Ñ
Detaching the trim plate
1) Detach accessory
7
to the unit.
7
Ñ
Installation the Digital Radio
antenna (DNX9180DABS)
#
CAUTION
• This film antenna is exclusively for use inside the
vehicle.
• Do not install at the following locations:
–
Where it may block driver’s view
–
Where it may obstruct operation of safety devices
such as air bags
–
On movable glass surface such as rear hatch
–
On the side of the vehicle (e.g. doors, front-side
windows)
–
On rear windows
• Signal strength will decrease at the following
locations:
–
On IR reflecting glass or where covered with mirror
type glass film
–
Where it overlaps with genuine radio antenna
(pattern)
–
Where it overlaps with window heating wires
–
When glass that blocks radio signals (e.g. IR
reflecting glass, thermal insulation glass) is used
• Poor reception may occur:
–
Due to noise when the windshield wipers, air
conditioner, or motor is turned on
–
Depending on the location of the broadcast station
in relation to the vehicle (antenna)
• Thoroughly wipe oil and dirt from the pasting surface
with the included cleaner (accessory
~
).
• Do not bend or damage the film antenna (accessory
!
).
• It may not be possible to install on some type of
vehicle.
• Check the cable routing of the film antenna (accessory
!
) and amplifier (accessory
@
) before pasting.
●
Installation overview
The antenna should be installed on the
passenger side for safety.
!
@
Antenna cable
(3.5 m)
●
Determining the antenna installation
location
• The direction of the film antenna (accessory
!
)
changes depending on whether the film antenna is
installed on the right side or left side.
• Be sure to check the installation location of the film
antenna (accessory
!
) before installing. The film
antenna cannot be reattached.
• Install the antenna at least 100 mm away from other
antennas.
• Do not attach the amplifier unit (accessory
@
) to the
ceramic line (black part) around the windscreen, as it
will not stick sufficiently.
When installing the antenna on the right
side
30 mm
@
Ceramic line (black part)
Earth sheet *
!
150 mm
When installing the antenna on the left
side
150 mm
30 mm
!
Earth sheet *
@
Ceramic line (black part)
NOTE
• *Where the earth sheet of Amplifier (accessory@)
can be pasted on the metal part of the front pillar.