Kenwood DNX9960 Instruction Manual - Page 116

Help? Troubleshooting Some functions of this unit may be disabled by some settings made on this unit. ! • Cannot set up the subwoofer. • Cannot set up subwoofer phase. • No output from the subwoofer. • Cannot set up the low pass filter. • Cannot set up the high pass filter. ▲ Subwoofer is not set to On. ☞ (page 94) ▲ The Dual zone function is enabled. ☞ (page 74) ! • Cannot select the output destination of the subsource in the Dual zone. • Cannot adjust the volume of the rear speakers. ▲ The Dual zone function is disabled. ☞ (page 74) ! Cannot play audio files. ▲ "CD Read" of (page 100) is set to "2". ! Cannot Folder select. ▲ The Random play function is enabled. ! Cannot perform Repeat play. ▲ The PBC function of the Video CD is enabled. ! • Cannot set up the equalizer. • Cannot set up the crossover network. ▲ The Dual zone function is enabled. ☞ (page 74) ▲ The DSP Select is Bypass. ☞ (page 93) What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. General ? The Touch Sensor Tone doesn't sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can't be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on . Disc source ? The specified disc does not play, but another one plays instead. ✔ The specified CD is quite dirty. ☞ Clean the CD. ✔ The disc is severely scratched. ☞ Try another disc instead. Audio file source ? The sound skips when an Audio file is being played. ✔ The media is scratched or dirty. ☞ Clean the media, referring to the CD cleaning of the section on (page 4). ✔ The recording condition is bad. ☞ Record the media again or use another media. 116 DNX series DNX9960/ DNX7160/ DNX7020EX