Kenwood G-EQ300 User Manual - Page 8
System connections
View all Kenwood G-EQ300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
System connections Make connection as shown below. When connecting the related system components, refer also to the instruction 8 manuals of the related components. 3 Caution: Do not plug in the power lead until all connections are completed. G-EQ300 (En/K) Malfunction of microprocessor If operation is not possible or erroneous display appears even though all connections have been made properly, reset the microprocessor referring to "In case of difficulty". ¢ Caution regarding placement ( Except for U.S.A., Canada ) To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below. Left and right panels: 10 cm, rear panel: 10 cm AV CONTROL CENTER SYSTEM CONTROL *CAUTION (For U.K.) When using the AC outlet epuipped with this unit, be sure to consult your dealer for the correspond-ing plug. * U.K. TAPE 2 (MONITOR) L R REC PLAY Connect to the TAPE 2 (MONITOR) jacks Set the TAPE 2 (MONITOR ) switch to the monitoring position. Audio cords Australia U.S.A., Canada, China and US military Other countries Audio cords TAPE PLAY REC IN OUT L LINE IN OUT L R R SYSTEM CONTROL System control cord To wall AC outlet AC OUTLET This unit LINE REC PLAY IN OUT L R Cassette tape deck (optional) Use the numbers 9 0 ! @ on the rear panel of this unit when connecting it to an AV CONTROL CENTER or RECEIVER. Connections are easily completed by using Audio cords to make connections to the same numbers on the other component. ÷When a cassette deck is connected to the graphic equalizer,do not connect the system control cord to the cassette deck. ÷When connecting the audio cords (cords with pin plugs on each end), insert the white plugs into the L (Left) jacks and red plugs into the R (Right) jacks. Notes 1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced. 2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging connection cords without removal of the power cord can cause malfunctions or damage on the unit. 3. Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.