Kenwood KCA-2020AVM User Manual - Page 14
Wiring Connection to Kenwood receiver
View all Kenwood KCA-2020AVM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Wiring Connection to Kenwood receiver Connection Chart of KCA-2020AVM to Kenwood Receiver SPD ToSpeed-Pulse sensor (if you don't connect, PVM still works) Car Reverse Line To Reverse gear sensor in the car KENWOOD H/U car To Reverse input in the Kenwood Reverse line receiver (NOT revserse line of vehicle!) B+ To Back up power ACC To Accessory power GND To GND TRNL LH ToTurn signal wire in the vehicle To Left side Camera connector To ECU/AVM RH To Right side Camera connector RR To Rear Camera connector FR To Front Camera connector Remark1: Plrase connect rightly for reserse line Remark2: If the signal pulse of speed/turn signal from vehicle ECU doesn't match the spec of KCA-2020AVM, please do not connect them. (Even disconnecting speed/turn signal sensor to KCA-2020AVM, some of view mode doesn't work but basic feature can work) 14 | Installation Manual