Kenwood KCH-20R User Manual 2 - Page 4

REPLACING THE PF NAME PLATE You can reconfigure the PF name plates at any time. 1 Remove the current PF name plate from the function key using a fine-tipped tool. 2 Punch out the PF name plate card, and insert the plate onto the relative function key. Name plate Squeeze and insert the plate INSTALLING THE microSD MEMORY CARD 1 Open the Cap. 2 Insert the microSD memory card. • Insert the microSD memory card with its terminal side facing the same side as the front of the panel. • Insert the microSD memory card until it clicks into place. • To remove the microSD memory card, push the card inwards once, then pull it out straight. microSD memory card Cap Note: ◆◆ microSD memory cards (Class 2 or higher) and microSDHC memory cards (Class 2 or higher) can be used. ◆◆ SDXC memory cards cannot be used. ◆◆ This transceiver is not guaranteed to operate with all microSD memory cards. (Operations are confirmed on memory cards for the following brands: SanDisk, TOSHIBA and Panasonic.) ◆◆ Use the microSD memory card within the allowable operating temperature. ◆◆ Do not remove the microSD memory card or turn off this transceiver while the microSD memory card is being accessed. ◆◆ The waterproof performance is not guaranteed if the microSD memory card slot cap is not fit into place. ◆◆ Make sure your hands are clean before opening the microSD memory card slot cap. Compensation Disclaimer Data stored on the microSD memory card may be altered or lost due to problems with this transceiver. We do not accept liability in respect of the data stored on your microSD memory card, failure to save the data properly, loss of data, and any direct or indirect damages. 3