Kenwood KDC-155U Instruction Manual - Page 4

GETTING STARTED 1 Cancel the demonstration When you turn on the power (or after you reset the unit), the display shows: "CANCEL DEMO" \ "PRESS" \ "VOLUME KNOB" 1 Press the volume knob. [YES] is selected for the initial setup. 2 Press the volume knob again. "DEMO OFF" appears. For KMR-355U , [DEMO OFF] is selected initially. 2 Set the clock 1 Press the volume knob to enter [FUNCTION]. 2 Turn the volume knob to select [SETTINGS], then press the knob. 3 Turn the volume knob to select [CLOCK], then press the knob. 4 Press the volume knob to select [CLOCK ADJUST]/ [CLOCK ADJ]. 5 Turn the volume knob to adjust the hour, then press the knob. 6 Turn the volume knob to adjust the minute, then press the knob. Press 4 / ¢ to move between the hour and minute adjustment. 7 Press and hold to exit. (or) Press and hold SCRL DISP to enter clock adjustment mode directly while in clock display screen. Then, perform steps 5 and 6 above to set the clock. 3 Set the initial settings 1 Press SRC to enter [STANDBY]. 2 Press the volume knob to enter [FUNCTION]. 3 Turn the volume knob to select [INITIAL SET], then press the knob. 4 Turn the volume knob to make a selection (see the table below), then press the knob. 5 Press and hold to exit. • To return to the previous hierarchy, press . Default: XX PRESET TYPE NORMAL/ NORM: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ AM). ; MIX: Memorizes one station or SiriusXM channel for each preset button regardless of the selected band or SiriusXM channel. KEY BEEP ON: Activates the keypress tone. ; OFF: Deactivates. PANDORA SRC (Except for KDC-MP255U / KDC-MP155U ) ON: Enables PANDORA in source selection. ; OFF: Disables. (« 8) BUILT-IN AUX/ BUILTIN AUX ON: Enables AUX in source selection. ; OFF: Disables. (« 7) CD READ 1: Automatically distinguishes between audio file disc and music CD. ; 2: Forces to play as a music CD. No sound can be heard if an audio file disc is played. SWITCH PRE (Except for KDC-X397 / KDC-355U ) REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected to the line out terminals on the rear (through an external amplifier). SP SELECT OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches or 4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance. F/W UPDATE F/W UP xx.xx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated). For details on how to update the firmware, see: www.kenwood.com/cs/ce/ 4 EN_KDC-X397[KWK0]f.indd 4 7/26/12 10:55:35 PM