Kenwood KDC-BT752HD Instruction Manual - Page 28

Installation/connection Part list: A Faceplate 1) B Escutcheon 1) C Mounting sleeve 1) D Wiring harness 1) E Removal tool 2) F Flat head screw (for Nissan cars 4) G Round head screw (for Toyota cars 4) H Microphone (3 m) (KDC-X796 only)B 1) Basic procedure 1 Remove the key from the ignition switch, then disconnect the · terminal of the car battery. 2 Make proper input and output wire connections. \ (page 30) 3 Install the unit to your car. \ (page 31) 4 Reconnect the · terminal of the car battery. 5 Reset the unit. (page 4) ¤Warning ■■The unit can only be installed in a car with a 12 V DC power supply, negative ground. ■■If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. ■■Disconnect the battery's negative terminal and make all electrical connections before installing the unit. ■■Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. ■■Be sure to ground this unit to the car's chassis again after mounting. ■■If the power is not turned ON ("PROTECT" is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked. ¤Caution ■■If your car's ignition key switch does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wires to a constantvoltage power source, as with battery wires, the battery may die. ■■Do not use your own screws. Use only the screws provided. ■■Install this unit in the console of your vehicle. Make sure the faceplate will not hit the lid of the console (if any) when closing and opening. ■■After the installing the unit, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. ■■Mount the unit so that the mounting angle is 30° or less. ■■If the fuse blows, first make sure the wires are not touching other parts to cause a short circuit, and then replace the old fuse with one with a new the same rating. ■■Connect the speaker wires correctly to the corresponding terminals. The unit may be damaged or fail to work if you share the · wires or ground them to any metal part in the car. ■■When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). 28 English