Kenwood KDC-MP205 Instruction Manual - Page 26
Connecting Wires to Terminals - wire harness
View all Kenwood KDC-MP205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Connecting Wires to Terminals To Kenwood disc changer/ External optional accessory (KDC-MP2035/MP235 only) ⁄ To connect these leads, refer to the relevant instruction manuals. FRONT Front right output (Red) (KDC-MP2035 only) Front left output (White) (KDC-MP2035 only) Rear left output / Sub Woofer left output (White) Rear right output / Sub Woofer right output (Red) (KDC-MP2035/MP235/MP205 only) Rear left output (White)/ Rear right output (Red) (KDC-MP235CR only) Fuse (10A) FM/AM antenna input If no connections are made, do not let the wire come out from the tab. Wiring harness (Accessory1) Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. P.CONT Power control/Motor antenna control wire (Blue/White) Connect to the terminal that is grounded when either the telephone rings or during conversation. MUTE ⁄ To connect the Kenwood navigation system, consult your navigation manual. ⁄ Do not let the wire come out from ANT. CONT the tab. TEL mute wire (Brown) Not Used (Blue) To front left speaker White/Black White FRONT L To front right speaker Gray/Black Gray To rear left speaker Green/Black Green FRONT R REAR L To rear right speaker Purple/Black Purple REAR R Ignition key switch Car fuse box ACC Ignition wire (Red) Car fuse box (Main fuse) Battery + 26 | English - Battery wire (Yellow) Ground wire (Black) - (To car chassis)