Kenwood KDC-MP4028 Instruction Manual - Page 31
Screwing the Faceplate on the Unit
View all Kenwood KDC-MP4028 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Screwing the Faceplate on the Unit If you want to fasten the faceplate to the main unit so that it does not fall off. 1 Refer to the section (page 32) and then remove the hard rubber frame. 2 Drop open the faceplate by pressing the Release button. 3 Tighten the stepped screw (Accessory 5) in the hole shown on the diagram. Accessory5 5 Tighten the screw (ø2 × 5 mm) (Accessory 6) and bracket (Accessory8) in the hole shown on the diagram. Accessory8 Accessory6 4 Tighten the screw (ø2 × 5 mm) (Accessory 6) and bracket (Accessory7 ) in the hole shown on the diagram. • Never insert the screws in any other screw hole than the one specified. If you screw them in another hole, it will contact and may cause damage to the mechanical parts inside the unit. Accessory7 Accessory6 Accessory5 Accessory6 ..........1 ..........2 English | 31