Kenwood KDC-X897 Quick Start Guide - Page 14
Installing/Removing the unit
View all Kenwood KDC-X897 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installing/Removing the unit Non-Japanese cars Removing the trim plate 1 Engage the catch pins on the extraction key (Accessory2) and release the two locks on the upper part of frame. Lift up and pull the frame forward as shown in the figure. Bend the tabs of the mounting sleeve with a screwdriver or the like and attach it in place. < • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). Japanese cars 1 Remove the trim plate with reference to . 2 Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws. 3 4 8 mm MAX. 8mm MAX. Lock Catch Accessory2 2 When the upper part of frame is removed, remove the lower part of frame. < • The frame can be removed from the bottom side in the same manner. Removing the unit 1 Remove the trim plate with reference to . 2 Remove the faceplate. 3 Insert the two extraction keys (Accessory2) deeply into the slots on both sides as shown. 4 Lower the extraction key toward the bottom, and then pull out the unit halfway while pressing the extraction key towards the inside. Accessory2 ø5mm ø5mm 14 | Quick Start Guide ! • Be careful to avoid injury from the catch pins on the extraction key. 5 Pull the unit all the way out with your hands, being careful not to drop it.