Kenwood KDC-X897 Quick Start Guide - Page 3
Before use
View all Kenwood KDC-X897 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Before use # WARNING To prevent injuries or a fire, take the following precautions: • Stop the car before operating the unit. • To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. ! CAUTION • Adjust the volume so that you can hear sound outside the car. Driving with the volume adjusted to a too high level may cause an accident. • Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure to observe this precaution may result in damage to the monitor or unit. Cleaning the connector The unit may not function properly if the connector between the unit and faceplate are dirty. Detach the faceplate and clean the connector with a cotton swab gently, being careful not to damage the connector. Connector Condensation When the car is air-conditioned, moisture may collect on the laser lens. This may cause disc read errors. In this case, remove the disc and wait for the moisture to evaporate. Notes • If you experience problems during installation, consult your Kenwood dealer. • When you purchase optional accessories, check with your Kenwood dealer to make sure that they can work with your model and in your area. • Characters that conform to ISO 8859-1 can be displayed. About the discs used with this unit • This unit can only play the CDs with . • The following discs cannot be used: -- A disc that is not round -- A disc with coloring on the recording surface or a disc that is dirty -- A recordable/rewritable disc that has not been finalized (For the finalization process, refer to the instruction manual that came with your disc writing software or your disc recorder.) -- An 8 cm (3 inch) disc (An attempt to insert using an adapter can cause malfunction.) Handling discs • Do not touch the recording surface of the disc. • Do not stick tape etc. on the disc, or use a disc with tape stuck on it. • Do not use any accessories for the disc. • Do not use any solvents to clean discs. Use a dry silicon or soft cloth. • Clean the disc by moving the cloth outward from the center of the disc. • When removing a disc from this unit, pull it out horizontally. • If the center hole or outside rim of a disc has burrs, remove them before inserting a disc. How to reset your unit If the unit fails to operate properly, press the Reset button. The unit returns to the factory settings. Reset button English | 3