Kenwood KDCX790 Instruction Manual - Page 42
G-Analyzer Calibration setup, G-Counter Level set, G-Analyzer Reset
View all Kenwood KDCX790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Menu system In Standby mode G-Counter Level set Calibrating G-Point. Setting the level according to the kinds of vehicles. Display "G-Counter : Level1" "G-Counter : Level2" "G-Counter : Level3" ... Setting Counter is easy to go up. Counter is hard to go up. • In the case of driving situations calling for few accelerations, set the G-Point up to "G-Counter : Level1". In the case of frequent accelerations, set it up to "G-Counter : Level3". In Standby mode G-Analyzer Reset Resets the value of G-Meter, G-Counter and GAnalyzer Horsepower Analysis. 1 Select G-Analyzer Reset mode Push the Control knob towards [FM] or [AM]. Select the "G-Reset" display. 2 Enter G-Analyzer Reset mode Press the Control knob for at least 1 second. 3 Select the Reset item Push the Control knob towards [FM] or [AM]. "G-Meter Reset": Reset the value of G-Meter. "G-Counter Reset": Reset the value of G-Counter. "G-Power Reset": Reset the value of G-Analyzer Horsepower Analysis. 4 Reset the value Press the Control knob for at least 2 seconds. "Reset OK" is displayed. 5 Exit G-Analyzer Reset mode Press the [MENU] button. In Standby mode G-Analyzer Calibration setup G-Analyzer requires calibration for horizontal acceleration and braking. • To ensure accurate calibration, go through the following steps at a level place where you can move the vehicle straight ahead. 1 Park the vehicle in a horizontal location 2 Select G-Analyzer Calibration setup mode Push the Control knob towards [FM] or [AM]. Select the "G-Calibration" display. 3 Enter G-Analyzer Calibration setup mode Press the Control knob for at least 1 second. "Stop" is displayed. 4 Start Calibration of horizontal direction Press the Control knob. Once "Move Forward" appears on the display, the vehicle must be advanced. 5 Start Calibration of straight direction Start moving the vehicle ahead. Calibration of straight direction automatically starts. When the Calibration is finished, "Calibration OK" is displayed. • If you fail to complete the calibraton, "No Calibration" is displayed. In such a case, repeat steps 1 through 6. 6 Exit G-Analyzer Calibration setup mode Press the [MENU] button. 42 | English