Kenwood KMM-100U Instruction Manual - Page 15
Basic procedure, How to remove the unit, Installating the unit in-dash mounting, When installing
View all Kenwood KMM-100U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
INSTALLATION / CONNECTION Basic procedure 1 Remove the key from the ignition switch, then disconnect the · terminal of the car battery. 2 Connect the wires properly. (See Wiring connection. (➜ 16)) 3 Install the unit to your car. (See Installing the unit (in-dash mounting).) 4 Connect the · terminal of the car battery. 5 Reset the unit. (➜ 3) Installating the unit (in-dash mounting) Bend the appropriate tabs to hold the mounting sleeve firmly in place. Do the required wiring. (➜ 16) Hook on the top side Orientate the trim plate as illustrated before fitting. Dashboard of your car When installing without the mounting sleeve 1 Remove the mounting sleeve and trim plate from the unit. 2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure the unit with the supplied screws. How to remove the unit ENGLISH | 15